Today was a intresting day, first time using a 3d printer, after a couple of strength tests settled on an infill and begun producing car parts, first up a winch mount that slots into the chassis rails.
Next up rear chassis stiffener and front servo plate redesign as the stock one has way to much flex.
And a mascot for the car.
Yep... and that spot is small... it's only around 200meter... i need a 400meter one...but can't find one with no traffic!
Yes, Portugal! 🙂 My home country!
Here is the edited video...
Yeah your card will work, just seems like an off setting on the esc.
As far as the OP is concerned maybe there was an issue with the v1 esc's and programmers, you should still be able to config it although tediously via the remote.
Yeah true but this is what confuses me.
Most my hobbywings had the connectors fitted by the model shop (you pay for them to do it etc), so does that mean they void the warrenty fitting them? Now i fit the connectors does that mean its void once you wire a connector too it?
Made a front bumper for my Hyper 7. Made from some 4mm thick black acetal.
A bit rough, but will give some bashing protection.
Gonna make a neater version when i pick up a new jigsaw and find my detail belt sander.
Bit of modelling.
Working on a speedrun body design, the idea is to print as a mould negative and then use it as a base for fiberglassing over.
Fancy Render