NBY Posted June 9, 2022 Share Posted June 9, 2022 Need some advise from a pro as I just can't figure this one out... I have got an FTX Outlaw with Arrma BLX100 esc and Surepass 3660 3100kv motor. It used to run fine but this week whenever I try to get going, it will drive for about 10 seconds and then would start cogging and then wouldnt go anymore. -Battery is 2s 5200 80c, fully charged -I turn it on and off-same issue after a few seconds. -I have reseted the esc back to default setting- didnt help -I have also tried setting the throttle limits on the esc-nope. Anything comes to mind? 🙏 Quote Link to comment Share on other sites More sharing options...
Stormbringer Posted June 9, 2022 Share Posted June 9, 2022 Maybe the battery is on way out ? Do you have another car to try battery in ? Has the lvc on esc been set to 3s somehow ? Quote Link to comment Share on other sites More sharing options...
locky Posted June 9, 2022 Share Posted June 9, 2022 Check low voltage cut off setting if adjustable, check solder joints on all leads/cables , heat shrink can hide a problem, otherwise process of elimination such as trying a different battery pack. Quote Link to comment Share on other sites More sharing options...
MrCake Posted June 9, 2022 Share Posted June 9, 2022 Ignoring the electronics side, does it move/roll fine? No binding or anything? Quote Link to comment Share on other sites More sharing options...
NBY Posted June 10, 2022 Author Share Posted June 10, 2022 Thanks for all your answers... Battery voltage is good and car rolls fine no binding. I will have to get a another esc and swap to eliminate issues i guess. I didn't know the esc can be set to 3s...but i seem to remember the default was 2s? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.