wombat

That's a handy looking driver, don't suppose you have a link for it, I'm currently using a cheapo from the Range

Excellent, what's your first impression of it ?

All the parts needed to convert the mauler to 4 wheel steering

Looking good 😀

For my power driver i use core rc bits from modelsport, and for hand held drivers i have a set of arrowmax amd a set of wera, would say the wera set is a tighter fit 😀

Where you not impressed with the Injora kraken claw tyres?

Mine cost £4.50 from aliexpress

Looking good 👍 Looking forwards to the test drive, and your thoughts on the dumbo rc, been looking at that one for a while

+1 for proper shock pliers, makes the job a lot easier. Get some with a pin attachment and you can wind rod ends on easily

Hi, I would charge that at 6.7 amps,

Hi all, just stripped down 2 sets of beadlocks and tyres to swap around the tyres, couldn't believe the amount of water in one set of foams, the other set was bone dry. One set of tyres are vented so thinking of sealing the vents, either with a small square of gorilla tape or a dab of silicone, as the local crawler course has some good water features What are people's thoughts on vented and non vented , and how do you seal your vents Cheers, Ian,,👍

That looks awesome, bet you can't wait to take it out 😁

Going against the grain, I like the spec but think it looks awful 😕

Iwould use gt85, lithium grease will attract dirt etc. In my axles i use some blue waterproof marine grease that i used for kingpins and bearings when i used to offroad a 1.1 suzuki jimny 😀

I fitted the kraken claws to my injora rock buggy and find them excellent, a lot better than the super swampers i origionally fitted . They are quite tall though I also have a set of the injora comp pins, that seem to be unstoppable, handling mud, roots, wet and dry rock with impunity., only slight downside is they do not look as scale as chunky tyres, but perform far better 😀