Jray2955 Posted July 31, 2023 Share Posted July 31, 2023 These don't seem to come with threaded internals to lock the pins into place has anyone came up with a solution? Quote Link to comment Share on other sites More sharing options...
Bajadre Posted July 31, 2023 Share Posted July 31, 2023 Usually have a thick like rubber o ring jray that hold the pin place ive found on most extenders Quote Link to comment Share on other sites More sharing options...
Jray2955 Posted July 31, 2023 Author Share Posted July 31, 2023 5 hours ago, Bajadre said: Usually have a thick like rubber o ring jray that hold the pin place ive found on most extenders Ah no these are a different design, very similar to the oem ones but they have a lock bolt through the center to pinch onto the pin. These do not so I estimate them staying in about 10 seconds 1 Quote Link to comment Share on other sites More sharing options...
Bajadre Posted July 31, 2023 Share Posted July 31, 2023 (edited) aww gotta ya buddy id prob dremel/file a flat spot half way so it has something to latch onto 👍 Edited July 31, 2023 by Bajadre Quote Link to comment Share on other sites More sharing options...
wolfie1 Posted July 31, 2023 Share Posted July 31, 2023 Do the nuts on the big thread move (the very end ones)? Do you maybe tighten the middle nut onto them and that locks the pin it? Failing that a bit of heat shrink over the pin hole Quote Link to comment Share on other sites More sharing options...
Jray2955 Posted August 1, 2023 Author Share Posted August 1, 2023 No unfortunately they don't move as that's what the wheel rim sits on. That's a good shout tho the Heat shrink idea I'll have to get some big ones. Quote Link to comment Share on other sites More sharing options...
Tug Posted August 1, 2023 Share Posted August 1, 2023 They don't look well designed, definitely can't see how the drive pin would be held? Quote Link to comment Share on other sites More sharing options...
Dun2504 Posted January 30 Share Posted January 30 I used the original threaded inners with mine , no problems. Quote Link to comment Share on other sites More sharing options...
JonnyUK Posted January 30 Share Posted January 30 (edited) If it was me, I'd message the email contact on the link below. Worth asking them how do they intend the pin to be held in place etc. Maybe it's a design fault that they aren't aware of. https://www.facebook.com/ATOPRC/?locale=nn_NO [email protected] Edited January 30 by JonnyUK Quote Link to comment Share on other sites More sharing options...
Dun2504 Posted February 2 Share Posted February 2 I bet they are designed to have a thread in the inner and they are wrongly machined. Never had an issue with ATOP stuff, but you could just use standard inners. I would contact them though in case it is a manufacturing defect. Quote Link to comment Share on other sites More sharing options...
JonnyUK Posted February 2 Share Posted February 2 Or maybe it's tapped for the next size up of grub screws... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.