hyper 7,broke again need help finding part.

[nick19800]

Ive got a mach .28 hyper7 and today i took it out to see what the new exhaust was like which was absolutely mental but anyway i blasted up the road, turned around and then came back past me and then literally it got about 20ft past me and i couldnt stop it, it just stayed WOT which wasnt good as i was heading straight towards a bollard but managed to steer it at the last second quite violently which caused it to flip over and the carburettor took the full brunt of the impact which wasnt good and ive managed to break the little nipple that the fuel supply pipe connects too at the botom of the HSN , I dont suppose i can actually buy the little collar with the nipple on it seperately and just replace that instead of a whole new carburetor???

Any help appreciated

[mad nige]

not 100% m8 but i think you may have to get a new needle assembaly ,or might be cheaper to get a new carb on ebay

[caseyj]

did your failsafe not kick in

[nick19800]

to be honest it was not even quarter the distance i have had it in the past so im i think the failsafe might need to be set up again and some new batteries in the rx lol

[MaphewFX]

Get the Fastrax Failsafe, i had no problems with it, always works

My friend has a failsafe which kicks in when you full throttle it for more then 4 seconds, lol.

Seriosly, get a battery pack for your RX.

good luck

[nick19800]

help I cannot find the part I need for love nor money I've looked all over the Internet and model shops, I can't even find a complete carb assembly

[nick19800]

I found the part in the states and its called the fuel inlet nipple but cant seem to find one this side of the river which isnt good.

[Servo]

Check the part number in your manual (or on line one) and I would guess they are largely the same for the carb as the .21, and help is here

http://www.modelsinmotion.co.uk/sparescate...asp?catcode=496