Features
1/10 Scale
CMS (Chassis Mounted Servo)
Adjustable front track bar
Universal front drive axles
Stamped steel frame rails
Enclosed receiver box
12mm wheel hexes
Adjustable front and rear bumper mounts
Adjustable width rock sliders
Two battery boxes
Aluminum motor plate
Adjustable body posts
Optimized ball cups for more fluid axle articulation
Adjustable rear shock mount positions
Telescopic driveshafts front and rear
Extruded aluminum driveshaft splines
One-piece rear axle design
Splined front axle with adjustable caster
Machined input pinion gear
Metal ring gear
Machined steel top shaft
Metal idler gears
Heavy duty 5mm diameter steel links
Metal ball bearings included
Source: Associated
View full news article
Here’s my new (to me) SMT10. I bought this off a member on here and I don’t think he’ll mind me saying it was in a bit of a sorry state. I did a full strip down, clean and rebuild, replacing any worn parts as I went. I’ve added a few bits inc the all important wheels, it also now has...
- Metal transmission
- Clod tyres
- Home made BKT decals
- Home made side panel decals
- 13.5 brushless motor
- High torque servo
Next thing to do is run it! Anything that breaks will get upgraded as we go. Can’t wait to give it some stick...
It dwarfs my drift car
Finished off the Evo.
What should of been Tommi livery, has been replaced with Marlboro
Also added:
Wipers
Mirrors (not included with bodyset)
Exhaust
Rear toe eye
Shark fin (to cover the antenna hole)
Panel lines
More pics in my gallery:
Build video:
Took the G6 out on one of my favourite local coastal paths, between Mousehole and Lamorna Cove, i might add that despite walking it countless times, i’ve never driven this stretch before, so each obstacle was new and most of them were very challenging and technical, with only a couple of alternate lines to take.