steephill

Looks good. I use the hycote stuff, I've had quite good results.

Looks brilliant @.AJ.👍 love the matt black. Did you paint the black on the inside or outside?

@TommyC

The top hollow balls have an o-ring each side. In the picture above it's the one on the left.

@TommyC yes, all the stock parts will fit that chassis 👍

@TommyC I have one of those chassis shown in the link. One of the hollow balls should push in to the top cap with very little force. I have a set of those shocks spare. I'll open them up and have a look.

Try placing them into the shock. One will fit nicely in the aluminium top cap and the other will press into the rod end on the shock shaft.

@StormbringerThanks mate 👍. I've been feeding the wildlife for a good few years. The garden has wildlife visitors day and night.

It didn't have a clue

tawny owl makes badger jump tawny owl comes flying in and makes the badger jump.

Took out the injora jeep out for some trail driving. I have the hobbywing esc in this and the injora esc is far better. The drag brake is fairly nonexistent and it's pretty lumpy low down.

The o-rings go on the top and bottom of the hollow balls. So slide one on to the base, attach the shock then slide on the other o-ring. You see that one of the hollow balls are larger than the others, one fits in the top of the shock and the other in the lower. Not sure which one without pulling one to bits. I don't always use the o-rings on the bottom of the shocks. They can become a little tight for my liking. Hope this helps.

Some figures from aliexpress. Ordered five random.

Yeah mate👍

Lowered the blazer high trail. Looks better than the stock height. Still needs a little more. Fitted some 1.9 beadlocks with the largest 1.9s I had. Removed the bump stops. The rear is fine. The front will need a short bump stop to stop the front tyres rubbing. Has a load of articulation.

New body and some trail driving.

Springs and stock servo mount to lower a Trx4 high trail, Trx4m parts and brass hexes for the sendero. And check out the name on these injora tyres for the Trx4m...

0.08 at 8.4!

Sounds like a good idea to me. I use mine regularly, good trucks👍

Yeah no worries 👍

I don't think I'll put it in the tarantula or IR40. I use those just for crawling so I don't want any weight higher up. I take the Bronco out on the hills some times so the extra wheel speed may be beneficial. It still amuses me putting bigger motors in trucks, can't help it.

New injora 370 motor and gearbox arrived today. Here's a couple of size comparison picture's ...

@Lone-wolf Thanks mate 👍

A few tawny owls in the garden last night. One of them was sat right in front of the camera calling out.