KM buggy to 5SC

[Oh How Original]

Gasket might be too thick?

Also, perhaps put the mesh on the outside Jim, generally a bit safer then if it rips or the glue let's go it doesn't tangle round your flywheel.

[Bigjimknickers]

Gasket might be too thick?

Also, perhaps put the mesh on the outside Jim, generally a bit safer then if it rips or the glue let's go it doesn't tangle round your flywheel.

That makes sense, I'll be sure to do that on my Mx G290 engine next time it's out.

As for the CY engine, I just stripped the head off it & went to put a new ring in it & it doesn't fit! God knows what I've bought there! So I just ordered another CY 34cc ring, hope I'm right.

[Bigjimknickers]

Fresh rebuild!

New piston ring, new servo saver, alloy servo bracket, spektrum 901 servo, fid servo horn, alloy t/b horn & all back together ready to test.

[Bigjimknickers]

[Bigjimknickers]

Fired up the baja today! Adjusted the tick over & brakes & it's good to go!

Really poor turning circle on this truck though, I put all the linkage together as per instruction manual so I'm not sure what to do to improve it?

Also wondered how much pre load to wind down on the rear shocks to make it a bit more controllable?

[Noj]

Extenders? They don't help...running stock front hubs will add some improvement.

[Bigjimknickers]

I've had a nasty bill in for a repair on my van, i don't want to sell thus as I'll obviously lose a stack on it but how much? Any ideas on what it's worth in its current ArtR form?

Opinions welcome.

[Bigjimknickers]

?

Anyone?