liner re pinch

[Davy Nitro]

Hi all

I am thinking about a re pinch has anyone had this done and is it worth doing.

Also how long will it last and is there anyone on this forum who can do this.

Thanks Dave

[mugen mark]

get tron on maxbashing to do it,quick service and he uses the correct tools,

[dlegend]

Jublie clib screw driver and an electric cooker is all you need

[Peter Griffin]

Jublie clib screw driver and an electric cooker is all you need

You're better off taking mugen marks advice.

[dlegend]

You're better off taking mugen marks advice.

why quote my post no need at all

[HATZY]

if you are unsure if you can do it or not, then take mugen marks advice. if you are confident that you can do it then take dlegends advice. it does work, ive done it myself a few times. you dont need an electric cooker though, a gas hob and a frying pan does the job nicely too. it only takes a very small turn on the jubilee clip though so do it in small incriments, like tuning, till you get the required pinch. also, make sure you use a good quality jubilee clip. as for how long it lasts, nowhere near aslong as a new liner but you should get a couple/few more gallons out of it if done correctly. it can only be done once or twice though before the aluminium wears off the inside of the liner

[Davy Nitro]

Ok thanks to all of you think I might take mugen marks advice

[DeadMeatUK]

Jubilee clips don't keep the sleeves shape, if you do it yourself you need to buy the correct sized tube clamp/collet

[mugen mark]

there the link, http://www.maxbashing.com/mbforum/member.php?1717-Tron ,read the feedback if you have any issues,

[Davy Nitro]

Thanks again.

Don't fancy doing it myself I will get tron to do it

[J.K]

Any ideas how much a repinch costs nowadays?

[mugen mark]

think it

[HATZY]

Jubilee clips don't keep the sleeves shape, if you do it yourself you need to buy the correct sized tube clamp/collet

ive never had any liners warp from doin it. if the liner warps, then youve probs done the jubilee up too tight. also if you are really worried about warping the liner then put the pistin inside while you tighten it up. just dont leave the piston in the top of the liner as it cools

[J.K]

think it