pipcars Posted June 19, 2016 Share Posted June 19, 2016 Hi I'm new to large scale brushless and I'm sure this has been asked loads, but electrics confuse me a bit. I've put two large steering servos in and it recommends a 6v independent supply. I have a battery and a switch but do I need a bec?, I understand that you disconnect the red wire on the esc. Is this correct? Cheers Paul Quote Link to comment Share on other sites More sharing options...
Tug Posted June 19, 2016 Share Posted June 19, 2016 Have a read of the sticky in the leccy section. That thread has good diagrams that'll explain a lot of what you're asking. 1 Quote Link to comment Share on other sites More sharing options...
Noj Posted June 19, 2016 Share Posted June 19, 2016 Which buggy, Esc and servos? 1 Quote Link to comment Share on other sites More sharing options...
pipcars Posted June 20, 2016 Author Share Posted June 20, 2016 It's nothing fancy, a Tamco X5 (feishen) hobbyking 150amp esc and two trackstar ts 700mg servos running on 6s lipo. Cheers Paul Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.