tolska Posted November 2, 2014 Share Posted November 2, 2014 Hi all I stripped my spur gear so I'll be needing to replace it, I have the spare part ready but not sure how to do this, I had a look on YouTube but don't seem to be any videos detailing how to replace it, I'd appreciate any help and advice given, I was going to go to the hobby shop but it's over a hour away and they want Quote Link to comment Share on other sites More sharing options...
speedods Posted November 2, 2014 Share Posted November 2, 2014 Undo the slipper nut and the rest is obvious.. Quote Link to comment Share on other sites More sharing options...
tolska Posted November 2, 2014 Author Share Posted November 2, 2014 This nut? I tried to undo the nut but it won't budge Quote Link to comment Share on other sites More sharing options...
speedods Posted November 2, 2014 Share Posted November 2, 2014 Yea that nut. Quote Link to comment Share on other sites More sharing options...
jordan_bench10 Posted November 2, 2014 Share Posted November 2, 2014 Stick your hand on the spur then do it hold on tight as it will try to spin Quote Link to comment Share on other sites More sharing options...
tolska Posted November 2, 2014 Author Share Posted November 2, 2014 The nut don't seem to want to come off... Quote Link to comment Share on other sites More sharing options...
tolska Posted November 2, 2014 Author Share Posted November 2, 2014 Stick your hand on the spur then do it hold on tight as it will try to spin Will try again now thanks Quote Link to comment Share on other sites More sharing options...
tolska Posted November 2, 2014 Author Share Posted November 2, 2014 All done, that was incredibley easy.. Can't believe hobby shop wanted Quote Link to comment Share on other sites More sharing options...
speedods Posted November 2, 2014 Share Posted November 2, 2014 Check the mesh with paper folder so its 2x thick, should get a heavy indent not a rip. Quote Link to comment Share on other sites More sharing options...
tolska Posted November 2, 2014 Author Share Posted November 2, 2014 Check the mesh with paper folder so its 2x thick, should get a heavy indent not a rip. What's the mesh? what do I do with the folded paper? Quote Link to comment Share on other sites More sharing options...
Cammie838 Posted November 2, 2014 Share Posted November 2, 2014 Undo the engine bolts slightly then push the engine towards your spur gear. Then take your folded paper and feed it between the spur and clutch bell by turning the spur gear. This will 'push' the engine away slightly creating a slight gap between the spur and clutch bell so just nip up your engine bolts then take the paper out and the spur should spin freely with no binding spots otherwise do it all again until its right...... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.