Ninjashunt Posted September 13, 2014 Share Posted September 13, 2014 My hyper 7 seems to apply brake when i take my finger of the throttle is that normal, rolling the car without the engine on it doesnt have any resistance when i have the throttle applied but when i take my finger off the throttle i can feel some resistance from the brakes. But the servo doesnt then move any further when i actually apply the brakes so no more added stopping power. However if i pull the brake linkage it does apply more so they are physically able too. Any help appreciated [emoji1] Quote Link to comment Share on other sites More sharing options...
froggy8 Posted September 13, 2014 Share Posted September 13, 2014 could you adjust the trims on your transmitter? Quote Link to comment Share on other sites More sharing options...
Ninjashunt Posted September 13, 2014 Author Share Posted September 13, 2014 that does make the brake work but the i'm left with a big opening in the carb, i guess i need to play with adjusting all linkages. Quote Link to comment Share on other sites More sharing options...
froggy8 Posted September 13, 2014 Share Posted September 13, 2014 yes just adjust the linkage and it should be ok Quote Link to comment Share on other sites More sharing options...
Ninjashunt Posted September 13, 2014 Author Share Posted September 13, 2014 i had overtightened the screws the linkage slides through and have now taken the whole thing of the servo and started from scratch with the trim in neutral . moved in the grub screws a bit and the brakes seem ok rolling it and with a bit more power through the rear![emoji106] Quote Link to comment Share on other sites More sharing options...
(Custom)(Custom)(Custom).thumb.JPG.2660545437631950b6f82e734d0a88f7.JPG)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.