CaptCaveman

hot wax is good as it melts and becomes a liquid that can be poured into and around any components.

Another good thing to use are condoms, as they got a large opening or wax, as you can melt it and pour it into any small spaces behind components.

1 thing he didnt mention is not too hold the iron on the wire too long, it causes the insulation to melt around the wire. And if you can use lead free solder.

only three leds lit and moving all leds lit the back of the leds the pcb i built to get them to move (apologies for the poor quality but im an electrical engineer not a photographer )

If you buy the number of leds you need, connect them to a 470 ohm resistor each then connect them to a power supply ie PP9 Battery via a micro switch, activated by your brake servo moving, youll get the same effect. Thats what I did and they work fine....I even decided to run a series of leds across the front of my hummer body just like knight rider and it looks pretty funky in the dark!! rofl

ITS ALIVE!!!!!! MUUAAHHHAAAA!!!!!! rofl

you definately wanna use a cover tho as the ali will get tarnished after a while of use and abuse that youll no doubtly do! id use warmed up yacht varnish, spray laquer or somat, the warming ensures a nice and smooth finish and the polishy jobby in the dremel kit is applied to a polishing disk doohicky.

chrs dude...gonna try to get a couple others aswell

well i think i could splash out a have a trip over the pennines tho wont be doing anything with car as im a noob!! Ill be the one in the Capt Caveman T-Shirt!! and have you got addy for it?

Where have Zircon and Flying Point gone???

Anyone help me with a problem? I seem to of misplaced 1 of my brand new Proline Maxx Masher #1075 wheel and tyres. Anyone know where i can get hold of 1 as they only come in complete kits of 4

yeah gotta admit between the vids and your guide this has been an ENORMOUSE help thanks alot guys again

Thank you very much dazzi220, I can actully tell that it now wants to start, tho it hasnt as yet, but again thanks again for all the help from everyone. Its just a case of fine tuning it now! woohoo

any ideas from where or if i can get a copy from someone?

thanks for all the info and yeah i guess i should of drained the engine but i still need to know how to set the needles to start it from scratch...ie stripped down and replaced