h_nitro Posted September 28, 2008 Share Posted September 28, 2008 Hey all You could say im a bit of a newbie to nitro. I have a problem with my throttle servo, well i think i do... When i put my servo in my new truck, i followed all the instructions of course, but i had to reverse it because it was going the wrong way. It was all working fine up until i flicked the switch. Then i hit a problem. I had the trim switch in the middle, it wasn Quote Link to comment Share on other sites More sharing options...
snowbl!nd Posted September 28, 2008 Share Posted September 28, 2008 Sounds to me as if the servo may not have enough torque to hold it's position. Does it stay put if you disconnect the linkages? Quote Link to comment Share on other sites More sharing options...
h_nitro Posted September 28, 2008 Author Share Posted September 28, 2008 this all happens when there is no linkage. as well as when there is Quote Link to comment Share on other sites More sharing options...
snowbl!nd Posted September 28, 2008 Share Posted September 28, 2008 Odd... Switch the throttle/brake and steering servos, at least that'll indicate whether it's the servo or receiver that's causing the fault. Quote Link to comment Share on other sites More sharing options...
h_nitro Posted September 28, 2008 Author Share Posted September 28, 2008 im thinking it is the revciver now. because it happens whenever i put the throttle/brake servoin reverse. even when i switched servos thanks Quote Link to comment Share on other sites More sharing options...
h_nitro Posted October 1, 2008 Author Share Posted October 1, 2008 hey it was the transmitter after all. i put the crystal into another transmitter and it worked fine. thanks for all your help hayden Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.