help speed passion brushless esc stoped

[Rollinlow]

I have a 1/10 speed passion brushless setup used it today it stopped an now when I try an run it it turns on fan spins but if you pull the throttle it flashes red an beeps loud an low. It does smell lime it's burnt have I killed it an why? Also any way to fix this what would of burnt of only used it for 10 mins

[Mitrab36]

Mine done the exact same thing. Did you get tit wet at all???? I got my Reventon R a bit damp and it played up for days. Fan constantly on, red flashing and beeps, but no output to motor......

 

So I stripped it down, lots of TLC from the hairdryer then reassemble carefully with a little silicone grease and its been better than ever since.

 

 

HTH.

[Danhaayes]

Mines done exactly the same

Sent from my iPhone using Tapatalk

[Rollinlow]

Yeh may have got abit wet lol went out in the sleat my first fan stopped so I replace it with a cheap one that runs at full on constant so I know its not overheated, did both of yours smell like its burnt aswell.

[Rollinlow]

Mines a rev r as well

[Rollinlow]

Taken it to bits an all the top of the board components are burnt, can it be saved I'll get a PIC up later but its the black chip bits think there called pic are they I'm no good at this circuit board stuff. It must have got water inside and burnt it