Brokey12 Posted April 23, 2013 Share Posted April 23, 2013 Hi , need a bit of help with my fg , a couple weeks ago I had to change the diff over because of the usual problem of the diff casing exploding as its plastic . I've opted for an alloy self locking diff ( used ) all fitted lovely with a diff raise bracket , however all put back together on the bench with the wheels off the ground it worked fine drive to both wheels no problem , when I put it on the floor it revved up the diff was turning but no drive to output shafts . Is this likely to be the shafts or the gearing inside the diff ? Quote Link to comment Share on other sites More sharing options...
Dan Garf Posted April 23, 2013 Share Posted April 23, 2013 check the squares that the wheel sits on the have set screw and can come lose this will give the same problem as you are having Quote Link to comment Share on other sites More sharing options...
FG Oli Posted April 23, 2013 Share Posted April 23, 2013 As said above more than likely the wheel squares. If it is then I advise to take them out and apply some threadlock so it does not happen again. Oli Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.