.jpg.2c35b3743014ab6e8fe0c9d07c59d9f4.jpg)
mark35
-
Posts
1,252 -
Joined
-
Last visited
-
Days Won
4
mark35's Achievements
-
.jpg.2c35b3743014ab6e8fe0c9d07c59d9f4.thumb.jpg.02ca4ab4795007b4ac5ff232d78f0bca.jpg)
Newbie to RC and this Forum - I want to build 1:5 2 stroke RC Car
mark35 replied to Monty_UK's topic in General - Petrol
Take a look at Taylor rc, they have all the good stuff there but be prepared cus it ain't cheap 😁 TAYLOR RC - THE PREMIER 1/5 SCALE UPGRADE SHOP https://www.taylorrc.co.uk/ -
The battery gets plugged into the connector from the on/off switch which looks like you have plugged a servo into. You want the steering servo in No 1 in the receiver Throttle /brake servo in 2 Killswitch in 3 And the other end of the on/off switch in B🤘🏻
-
Hi bud try 1 1/4L 1 1/2 H They should get you close enough 👍🏻
-
The settings I give a factory settings there is no perfect settings I can give as there are so many variations but they won't be far from factory, to keep it running turn the idle screw in. It would also be a good idea for you to grab another spark plug as they can get fouled whilst running in👍🏻 Btw the plug is a Ngk CMR7H
-
Best setting will be close to L 1 1/4 H1 1/2 👍🏻
-
Sold... please close🤘🏻
-
Here for sale is a scott Finlay G340 promx with Alx 70mm clutch and 19T pinion , 1107 carb, outerwears on pull start and filter, also has the killer bee harness wired in but no bee included. This engine is a real powerhouse and os in full working order, the alx baja clutch system is new fitted but never ran and retail for €250 alone. Asking price is £350 plus postage or pick up is fine. Thanks...Mark
-
Search for "Zenoah plug cap" bud👍🏻
-
Wow.. That's not gonna be a cheap fix.. Lol Either signal loss or duff t/b servo is the likely cause, You should run a remote killswitch to prevent this from happening again
-
Could be heat transfer from duff clutch carrier bearings
-
FS Racing Car 1/5th Petrol Control Issues
mark35 replied to thenorfolkoracle's topic in General - Petrol
Fail safes are crap, if you do what most people would recommend and set it to full brake and full turn then say you switch the tx off but forget to turn the rx off it will be bye bye servos and we all know they ain't cheap, as mentioned above get a killer bee or the more pocket friendly switchblade killswitch and forget about the failsafe imo👍🏻 -
You don't need it, it is for a different carb model. I'm pretty sure it is a seal for a drain off plug
-
If you block the carb opening and pull the engine over a few times that will choke an prime the engine
-
40ml oil to 1L of petrol=25:1 25ml oil to 1L of petrol=40:1 👍🏻
-
Just a new starter pawl should get you going, you could also file the flats on the flywheel too. Also that is a lightened flywheel you have there if you didn't already know 👍
