-
Posts
166 -
Joined
-
Last visited
Content Type
Profiles
Forums
Prizes
MSUK-Forum - RC Model News and Community
Articles
Events
Everything posted by Sharkster
-
does anyone know if u can still use the self righting if u change esc to a hw max 6
- Show previous comments 1 more
-
This in an X-Maxx?
It would work...but it also puts massive stress on ESC, wheels, drivetrain, and just about everything as it's effectively spinning the wheels one way then the other under no load until it throws the car to the point where a tyre bites and flicks it upright.
BarnetBasher used to do it with his Kyosho truck...but then...he also used to twist driveshafts, ruin diffs and burn ESCs as well as balloon tyres off the rims. I never considered it clever.
-
Cant get my XMAXX wheels off,the nuts wont budge,never had this problem on any other model
-
Can you use a normal lipo charger on the traxxas id lipos or do u have to use the traxxas id charger as just bought some and didnt realise they didnt have a external balance lead
-
I cant make my mind up on my new RC
Traxxas X MAXX OR Traxxas XO-1
Both have good points i like,what do you guys think is the better choice
-
would you say a Traxxas Xmaxx is better than a Traxxas Erevo brushless for fun and bashing
-
does any1 know if you can buy replacement fans for a mamba monster 1 esc that comes with the brushless e revo and if yes where
-
You can also decamp the esc (remove from case) there be a little connector plug (black n red wires) unplug that and slip the esc board out of the body. inside the plastic bodywork you will find what looks like a 40-60 mm fan, moreso the 40mm. on that fan is a sticker n it says something like 12v 0.3ah. take note of that rate on the fan.
now goto the local pc stores online ( maplin - amazon and likes) punch in 4cm or 40mm pc fan and check the numbers you wrote down and match to a fan. cost is not very much 3 quid to around 5 quid.
when it comes just lop off the old connector from the knackered fan, chop of the pc styled connector and solder your hobby connector on. plug it back into esc remount esc and lock down the case. your esc fan should now work and spin up (its also a little more quiet for now but will soon get noisey again)
-
whats the best gearing setup for the firestorm flux,i have used the bonus speed pack of 77 spur and 35 pinion but that only works for a short while then the esc overheats
-
3 different servos and not one fit in the firestorm flux,am i doing something wrong or is it very picky what fits