danharrison

no i can't go that low i could do it for

nice i think i will be doing that thanks

yeah the reciever will power that

thanks for the reply where can i get the rpm arms from? i had thought about putting 2 fuel tanks in. how did you make the 2 fuel tanks work? with a small pump? or just gravity fed?

one of the links could have snapped take of the shrink wrap and inspect the connections.i think it would charge for a bit, if a cell was dead.

please close

hi all just got a team associated monster gt 8.0. i was just wondering what spares i should stock up on? also any set up tips for this truck

i have tried connecting it to losi for a update. it made no differance. i have a spare sensor cable and a spare motor and neither of these made any differance it seems to be in the esc. i think it is the sensor part though but in the esc. it is still in warranty i have only had it about 6 months this will be the third time i have sent it back for repair. gonna take it back to ms tomorrow thanks for the replys dan

hi all, i took my buggy out yesterday all was going well. it had just run out of battery. so i changed the battery and waited for the motor to cool, when i started it up again it went for about 30 seconds then stopped. i then took a closer look at it. it will spin the wheels intermittently from stood still but when i put it on the ground it jerks a bit then won't move. but if i push it of with some throttle on it will set of and be ok untill it comes to a full stop again. i took it home and tried fitting my spare motor which made no difference. the confirmation lights work for full forward and full reverse but the motor won't spin till i give it a bit of help. any help would be much appreciated

the packs may have been supplied fully charged do you have a discharger? if you do try discharging them and then recharge them.

the tweeter speakers give out the higher pich noises. do they work? if so they don't need replacing if its just one side thats off i would just replace one side i can pretymuch guarantee that you won't notice a difference you could just pop down to halfords and get a cheap set of speakers like this http://www.halfords.com/webapp/wcs/stores/...tegoryId_165707 not sure if they would be the right size but they have a range of sizes. that kind come with tweeters and halfords will fit them for you if you want

here is mine

i once left my car in the local car park for 10 mins to come back and find my rear bumper on the floor and the rear arch dented

its just wax/polish for ensuring the mould releases

sounds ok to me to i would use smaller connectors than tamiya plugs tho what about bullet connectors or summat similar

yes at one end on the side of each cell there is a indent the smooth side is -

don't worry it should be fine

check the switch mine went faulty and it gave symptoms like what you said

my mate put a vxl in his durga for a while it was very fast but it seemed to get very hot and there wasn't much room for the esc. we had to cut bits out of the chassis to make it fit i run a losi s 6.5turn in my buggy and its ideal perfect match of power top speed and battery life

omg

you could make one with a few bulbs in a circuit

i have one of these http://www.wheelspinmodels.co.uk/item/NR91...scharger__3340/ my packs always take more than the rating when i have discharged them just re read u'r post this won't do 9cell

hi all can anyone advise me on any similar models to the traxxas revo? i am wanting a nitro model for hard bashing and i have heard lots of good press about the revo. although i am not set on it yet my requirements are; must be very capable off road and be able to have good ground clearance must be able to easily take large jumps must handle well(i don't want it rolling over everytime i go around a corner) 4wd 40+mph either a truggy or monster truck or similar i don't really have a budget but ideally around

thanks guys i think i am gonna try some then i'll let you konw what they are like

http://www.wheelspinmodels.co.uk/item/FAST...n-Rear-2__749a/ if you have what are they like? do they last well? are they grippy? and on which surface do they perform best?