Virdi

Hi all, So I have recently bought a used Senton 3s BLX It seems like a great truck but the issue I have is that I am struggling to keep it straight when putting down the power. It seems to wave a fair bit and then I am constantly having to counter steer it etc.. to keep it straight. Anything you guys could suggest please? Thanks

Hi all, I have an Arrma Vendetta and need some help please. The ESC is a Spektrum FIRMA series ....and all I get is a constant red flashing LED. I have tested the Receiver in another car and it works. I am pretty sure that the issue is with the ESC itself and I have tried all the basics.... I cannot get it into calibration mode either Anybody have any ideas please? Thanks

Fab! Many thanks!

Hi all, Quick question please. …..do the Hyper ST’s use the same diff parts as the Hyper 7’s please? thanks

Hi all, Does anybody please know if the Arrma Senton 6s comes with grease or diff fluid inside the diffs from factory? thanks

Hi all, I am selling a HPI Trophy Buggy Flux - This is very very clean - It's as new! Collection preferred - I am located near Ealing Hospital. £250 ono please

Hi all, I’m sure this has been debated Many times. ....what would your recommendations be on diff oils for the Hobao Hyper VSe please? i know I don’t want the fronts ballooning so I always go with 500k in centre. ...should I go with 7k in front and 5k in rear? I won’t be racing just general bashing in park. Thanks

Cheapest way to do it is a mount from AliExpress and the Losi battery tray is best

Have a look here.

Hi all, I’m sure this has been debated Many times. ....what would your recommendations be on diff oils for the Hobao Hyper VSe please? i know I don’t want the fronts ballooning so I always go with 500k in centre. ...should I go with 7k in front and 5k in rear? I won’t be racing just general bashing in park. Thanks

OMG! - you were right!! Thank you so much DAMN! - There trucks are so cr@p.

Brilliant conversion to do! I love mine so much that I made two!

Mod 1. 5m shaft (if you have the original motor)

Hi all, So I installed a light brushless system into my ECX Ruckus and after about 30-40 seconds ....I am getting symptoms of the clutch slipping. But I have double checked the clutch and tightened it ...but I am still getting hardly any power when I give throttle.? It just feels like extreme clutch slipping ....but I don't think it is the clutch I even opened the gearbox and diff - everything seems fine. Has anybody come across something like this before please? thanks

Price?

Hi, where are you based please?

Broke mine the other day

Aaaah! Thank you. so what about an older DX2E transmitters? Were they DSM2? Thx

Hi guys, I have DX2E (DSMR) transmitter and a SR3300T Receiver ....and I can’t get them to bind... ....I take it they are not compatible? Thx

Link to the heat sink please?

Hi, please can can you confirm which centre driveshaft? Pics would also be great. thx

Hi all, Do the Hyper SS and Hyper 7's all run identical diffs please? As I am currently working on a Hyper SSe Cage ...and I need to swap out the rear diff. Was wondering if could just use a Hyper 7 or Hyper ST diff? Thanks

I think someone may have removed mine must be the older version with orange chassis

Strange ...I don’t have those chassis rails ?

Hi all, please could any Hobao Hyper SS cage buggy (electric) owners confirm if they are meant to have chassis braces? thanks