dye29

im in need of the pinion gear and ring gear for the losi 8ight 2.0 any ideas where I can buy please

hi can anyone tell me what oils I need please for the diffs on Neo ive been told its oil then grease .

hi all can some kind person tell me the base settings for the losi 350 nitro engine please

Any factory settings for novarossi loco please 3.5

Hello all ive just acquired a novarossi loco engine but doesn't seem to run right not even on tick over so ive fully cleaned carb fresh fuel and lines but still no good . does anyone know the factory settings for this please so I can get started at least . thanks very much

hi all first thing does anyone recommend and tyres for the RF5 as stock ones are poor , also the clutch is there different types as from new this takes ages to set off im easy on half throttle before it moves and then it doesn't move fast at all .

My bad ill try again

good evening im unsure what model losi this is if someone can help please and I would like to know the stock settings for engine .I will add another pic of buggy tomorrow . IMG_0593.HEIC

Thank you very much for advice

good evening all I have just purchased the above but don't know much about these , are these good little buggies also what size lips can I use on this .

hi all I purchased a brand new hyper 7 mach 28 early in year but from day one its a nightmare to start even though I warm the engine , so I haven't even run this in at all I just chucked in box and left it so now im starting again can anyone tell me the factory or good settings to get this thing started please thanks ste

hard to say really when I press throttle fast it will die but if I press it smooth and steady she builds up power ok

hi all ive just run in my new hyper 7 mach 28 and as im tuning when I go too press throttle fast she bogs down but top end is max screaming so I was thinking its the low end needle , ive tryed richening this another half turn in increments but still no good so then tryed leaning it same half turn in increments and still bogs any tips please I have heard these engines are crap but is it my tuning skills haha please advise

a strange on after reading loads of posts on factory settings ive put HSN to 4.5 turns out and LSN 3.5 turns out from flush and she starts and runs surely that's too much is it

Sorry ignore the pic as i had needle fully out to change oring