ced64k

- Hobbywing Ezrun 9T + 60A V2.0 ESC - Turnigy nano-tech 4000mah 2S 40~80C Lipo Pack - Turnigy 1258TG Digital Titanium Gear Servo

Nice, then you keep it ?

Little video from this week-end

No. They didn't updated the picture. The T-plate has been updated last year and you already have the updated part (presumed stronger :/). If you order the plate, you get the updated one.

It's a classical And even on the Kyosho Ultima SC. The part costs 2,66$ + 3,99$ shipping. APE RC made an aluminium replacement part for the Ultima. It's possible to use it on the Turnigy but it needs some adaptation.

I hadn't seen this topic before, so I post my message again My setup: - EZRUN Combo 9T (4300V) + 60A V2.0 ESC - Turnigy 1258TG - Upgrade Front susp Arm - Upgrade Wheel hub - Upgrade Rear susp Arm Holding Block - Turnigy nano-tech 4000mah 2S 40~80C I didn't run much because I had a problem with the steering. I must say that this is the first kit I mounted. When I turn right, the steering doesn't return well in central position. The adherence is very very low and the car spinning on itself if I accelerate too much. And now I ordered these parts: - Pro-Line PowerStroke shocks - Pro-Line Caliber M2 Tires (not received yet, "economy int'l shipping", grr) - ST Racing Aluminum steering rack - Traxxas Differential Oil 50K I have to buy shock oil, I think putting 37 and 32.5 Losi. And the STRC steering rack is not a direct fit because Turnigy has updated the design and the sleeves are now molded directly in the part so I ordered the Kyosho sleeves. To use oil in the diff, I'll put Loctite gasket maker.

I made a video with the problem

Hey another Turnigy I bought the same kit last year with this setup: - EZRUN Combo 9T (4300V) + 60A V2.0 ESC - Turnigy 1258TG - Upgrade Front susp Arm - Upgrade Wheel hub - Upgrade Rear susp Arm Holding Block - Turnigy nano-tech 4000mah 2S 40~80C It was late summer, I didn't run much because I had a problem with the steering. I must say that this is the first kit I mounted. When I turn right, the steering doesn't return well in central position. The adherence is very very low and the car spinning on itself if I accelerate too much. I just order new parts and I hope this will solve the problem - Pro-Line PowerStroke shocks - Pro-Line Caliber M2 Tires - ST Racing Aluminum steering rack - Traxxas Differential Oil 50K

I bought a genuine B6AC with power supply on HobbyKing : )

Found 4mm locking washer with external tooth, I hope it will fit, thx

Hi, I lost one wheel serrated whasher on my FTX Carnage. I can't find this small part in the parts listing. Is it possible to order it ? I check on my local DIY shop but it's to small, they only sell bigger ones. Thx