PNuts

run a 15t Firebolt as mentioned above in my old skool Tamiya fighter buggy, with a 15t esc (cant remember brand) I upgraded just about everything else with it too: tyres, shocks, pinions, bearings etc it was still uncontrollable, but then again it was 2wd!!

this is the problem I seem to be having, I have reversed the channels (in the pic on bottom left of pic I flicked it down) but me and my father in law both swear it runs faster in reverse; I might un reverse the channels and run red to black wires etc.. thanks

Hi everyone, I have purchased myself a new rc buggy - after spending far too much on my Tamiya fighter buggy rx I have upgraded to a 4WD HSP XSTR Microtron - reviews seemed pretty good and with the possibility of brushless etc. I plan on putting my 15t clash motor in and esc set up etc.. I only paid

lovin the stance on that last pic

Scarecrow - replace the shocks with alloy ones 100% - the improvement is immense. I have a 15t motor in mine and it rockets, uncontrollable its going to be brushless isn't it? I can tell

I love em, ive had my fighter buggy for about 15, would be interested to some of your projects, cheers

Thanks very much - hopefully it'll look a lot different to most fighter buggies

ok heres a few - still need to paint the shell will upload more later - just gotta paint hell and rear wheels to match and a few other little personal touches

new axle shafts courtesy of 'Chewbacca' and some election gubbins lol still waiting on my new aerial mast though

well thanks to Chewbacca and noj for the items and the ret of the advice im back up and running again!!!

ill have a look thanks for the tip, soon this car be ready to go lol

right before this thing becomes the death of me - we have yet another issue lol (I know they're often simple but so frustrating.) so ive just received my standard Tamiya fighter FRONT wheels (much appreciated Noj) but they dnt seem to fit?? I was running mad bull wheels (as per pic) it seems the shafts are too long now???? ive just measured it and they roughly 2.8cm long (at some point have I put longer wheel shafts on?????) as currently the wheels slide left and right. I know I must have done something silly here. Thanks.

perfect thank you - ill inspect it, cheers for the advice

soo - major update time.. Have new ansmann oil filled shocks fitted, which really help the handling, wider rear tyres and standard front tyres on their way (thanks to 'Noj') brand new 15t motor complimented by an Anderson 15t ESC. If anybody saw I picked up an unknown nitro Tamiya lexan shell - I have cut and chopped that and its almost ready to fit!! couple of points, I find it really hard to tighten one of the rear wheel nuts - it goes on so tight but after that it spins the shaft and therefore the motor, and then the wheel just wobbles. This then in turn wont make the car run under load. Anyone know why this happens, does something need greasing? Thanks.

all up and running - thanks guys - yep I chopped the posts off and mounted it flush - its pretty nippy; cant wait to fit the new 15t motor!!!