vwsplitty

No one? Sent from my iPhone using Tapatalk

Hi As the Title says really. I have just bought one for my dad off of that well known auction site. It has been used 5 times and so has run but I am a competed newbie for these drones and want to get the best out of it and set up ready. 1.I have had a bit of a read up and it seems people either use baseflight or clean flight to set up. Is one better that the other ? 2. What are the best size battery's to use with your it. Smaller lighter 3s 1300mah or larger heavier 2200mah? 3. I purchased the flysky ia6b rx and flysky i6 tx does any have a set up guide to putting this in and wiring it up Any oth r advice? Cheers in advance Sent from my iPhone using Tapatalk

Old post but do you still have the quad?

Do you still have the charger with xt60? Why's your best price on it? cheers

What are you using/flying for that? Sent from my iPhone using Tapatalk

How much? Sent from my iPhone using Tapatalk

Bump Sent from my iPhone using Tapatalk

Haha that was a long time ago. Still going ok but haven't really used it much since late 2012. I was ragging it somewhat with 6s. Trying to get my little boy in to it but think he is still too young. Sent from my iPhone using Tapatalk

Soldered it back on and all running ok now. Cheers Sent from my iPhone using Tapatalk

Thanks for quick replies guys. I will resolder and let you know. The screw was from Another motor I had as this motor had one missing but it doesn't screw in all the way. Any idea where I can get those little screws from turok007? Sent from my iPhone using Tapatalk

Hi I took my erevo out for a ply this afternoon and I must amid I was running it quite hard then suddenly it sounded like the pinion or spur had come off. I stopped it straight away and below it what I found. It appears that one of the esc/motor bullet connector has unsoldered?? I can't think out it could get that hot to unsolder but not do any other damage to the plastic or such. Also what would make one wire suddenly do this and the others are fine? Will I be ok to just chop the wire and remake or do they need to be a certain length? Sent from my iPhone using Tapatalk

Thanks for letting me know. Think I'm going to go with a drone option I had been eyeing up. Sent from my iPhone using Tapatalk

Hi does this inc everything to be running out of the box? And look new? Thinking of getting it for present Sent from my iPhone using Tapatalk

Ok thanks Sent from my iPhone using Tapatalk

Sorry to bring up and old thread but as I have said in a few other posts be away a while and it seems like I have forgotten most things but luckily the people on here are all very helpful. Took this out today to have a spin and my pinion gear can loose and it got me thinking about this question again. Now I didn't get much run time only about 10mins but what kind of temperature should I be looking at on my motor with the same combo as before but now a 20t pinion and 58t spur gear? And one side question is does anyone know what size screws are in the end of the motor holding the back plate on I have one missing and want to replace it. As always thanks for any help. Sent from my iPhone using Tapatalk