conchp
-
Posts
339 -
Joined
-
Last visited
Content Type
Profiles
Forums
Prizes
MSUK-Forum - RC Model News and Community
Articles
Events
Everything posted by conchp
-
Hi team I'm new! Who else ownes a "sprint 2flux"
conchp replied to GWtaylor's topic in General - Electric
if its just a case of the grub coming loose and the wheels not tightened and it runs fine then dont see why it would be bad one . it looks nice on the pics -
was just gonna get some ideas mate, anything ill do im not happy with i wont put on ahahaha
-
Any cheap mods to make my fg baja look better. DIY wise ?
-
is it allright putting 6v nimh pack into transmitter? any benifits
-
Okay looking at this Flysky FS-GT3B would it work with a jolly rodger kill switch on my fg baja? cheers
-
-
-
Got a pic somewhere aha, its still not finished as there's 3 other projects hes on i think ahahah
-
got an mr2 at work, Track car, Evo v rear end & front, rally spec evo engine, think its on like 400hp not to sure , its mental
-
that looks sweet mate !!!
-
how much ?
-
ahaha thanks guys
-
is there a right way to get the square off?i cant seem to loosen the 2 grubs on any of the wheels?
-
nice one, looks good mate
-
no idea mate
-
Has anyone got a link to a cable clamp for my fg baja? at the moment the breaks are on the back, is the cable clamp all i need to fit the front cheers
-
did you get a new shell or spray over the original mate?
-
what would cause my pullstart to not ravel back? took it off and its not the flywheel ,the spring ect all are fine, including the large raveled up spring?
-
head gasket had fuel all over it so guessing thers one air leak, ive replaced with new one but not ran yet, fingers crossed
-
baja on stock needle settings, but when started it revs high, if i turn the idle screw in it just slows then cuts?
-
Screwing the idel speed screw in should speed up the revs. Sounds like you have massive air leak somewhere and reading your threads id not be surprised if that engine is scrap. When the carb came loose it will suck dust in and ruin the head/piston not to mention the damage from incorrectly fitting the piston ring. Your best bet is take it to rossmods if thats your closest LS shop and get them to check and set it up for you
-
-
it starts, revs up when i try to turn the idle down it cuts?
-
ahahahahah
-
oops looks like the heads rattled its way loose hahahaaha that must be the problem, loctite them now ahahah
i went to collect a FPV screen from a sell in china but said good where in manchester the place had containers in the yard from china and was a huge warehouse full of chinese workers 
so yeah they can be in manchester .jpg.2c35b3743014ab6e8fe0c9d07c59d9f4.thumb.jpg.02ca4ab4795007b4ac5ff232d78f0bca.jpg)