Thanks mate! Will have a lot of reading to do 🙂
I don't want to jump from topic to topic, but this thing keeps bothering me - rear wheel alignment.. Is it suppose to be like this?
Iv drawn lines to make it more obvious (red - rear; green - front)
I had this issue last week but it was shorter in duration, so i thought it was nothing, but now.... unfortunately i dont have anything to replace it and try again... Could you recommend some decent controller? Thank you!
Had an issue during todays run - at one point i lost all control for 2-3 seconds and the car was maintaining previous speed/direction - couldnt brake or turn (little bit of pee came out...). Gladly no one got hurt and the car survived the crash. Whats to blame here? Should i replace Traxxas controller? Im running MAX 6 with stock motor/controller.
If mechanically steering mechanism is free to move in both directions i would suspect servo defect. Not related to the problem but I would suggest using longer screw for servo saver and screwing a nut from the bottom side because you will get tired of tightening it up every or every other run when eventually threads will strip.
Injora parts arrived - had some fun replacing parts. I feel like watch maker while working on 1/18 model 🙂 Wheels are too big (62x20,5mm) - ordered closer to stock (56x22mm). And since we had a "car" crash - didn't see my sons Bronco and ran over it with my Xmaxx.... Had to order new body 🙂
Run time depends on your drive pattern - if you go top speed it will drain batteries faster. Can't comment on these, but i get 20-25 mins with my 6700mAh running at low/med speeds. Will these fit in the stock slots or are you planning to do some chopping? 🙂
Must have for RC owners! Clutch is so soft, im running it on 7th position and and only after that i tighten with hand torque. And by hand i mean same tool, just using it as regular screwdriver.