Mattymdm

Well if anyone is feeling it tomorrow do you want to comfirm on here around 9-9:30pm?

I'll pop round with mine and see if i can get it running or one of you guys could help me?

Yes i did the hsn 2.5 turns out and lsn just below flush

Right finally got it started but it takes my throttle trim set to full open and i cant get it to have a steady idle , what adjustments do i need to make?

Cheers Ian i will try what you have said And hopefully i'll have it running today

Going to watch this been a rush owner myself

Done factory needle settings and had a good charge on my glowstick , fit a new glow plug , cleaned air filter and have fuel into the engine. This fuel isnt been ignited as its pouring out of the exhaust. Flywheel is fine ian. Im out of ideas now

Anyone fancy a bash today around ls14? Maybe temple newsam or roundhay park? And you can have a look at getting mine running

Shudson i opened the throttle with the trim and still no go and had someone applying some gas when i was trying to start it but no luck. Ian i will have a look and see if its tight

I'm getting nowhere here guys , still cant get it to start not even any life and have a lot of fuel coming out of the exhaust. I've messed around with the needles of still nothing , anyone know the factory setting for my t15 engine? Any more ideas on how to get it running all im getting are blisters on my fingers

Cheers for the help guys, my glow stick is now flat so im going to give it a good charge and try again tomorrow!

Yeah just tried and had no luck , still tight turning over and lots of fuel coming out of the exhaust

Cheers , i will try and report back.

Hey guys i have a hpi rush evo had a new engine a couple of weeks ago ran about 10 tanks through it now i cant get it to start , had the model shop look at it twice and they have said they have sorted it but it not better, lost all hope for then so i will be attempting to fix the problem myself. Onto the fault then. Got a non start , glow plug is glowing and got 1mm gap on carb and fuel going into the carb fine, the pull start is very tough when the glow plug is in but then if you take it out and turns over nice and freely. Only thing im left to try is a bit of heat on the engine to free it up as its a new engine could it just be tight for a while?

Might see you bashing there sometime the dave! Not sure where abouts the lagoon is though and im local enough i should know but i dont