r083rtd
-
Posts
118 -
Joined
-
Last visited
Content Type
Profiles
Forums
Prizes
MSUK-Forum - RC Model News and Community
Articles
Events
Everything posted by r083rtd
-
Thank you all for the comments. i think its between a firestorm and a blitz. i think that the FTX sidewinder looks just as reliable as my trophy Rob
-
-
In the past i have had a really bad experience with HPI and there parts support. I had a Trophy truggy flux. it just seemed to constantly be broken. some how i managed to sell it. ill have a look at the fire storm but as i said i'm a little apprehensive about hpi.
-
i was just wandering if there were any scx1 groups in the south east (kent or eastsussex). Rob
-
its probably the best
-
Dear All, I have an axial scx10. as fun as it is, its a bit slow. i could change the gearing and motor on it but i like how well it crawls and climbs. so, i'm looking for another RC. i was looking at the ftx sidewinder but there doesn't seem to be great parts support. this leaves me with a dilemma because what i am looking for is an RC which is: cheap (sub
-
I've had my honcho since august and since then I've changes the servo and done a bamboo mod on the steering link (PM for Pics). Now i think it is time to do an upgrade on the link set up. The lower rear links flex quite a lot and the front 3 link constantly pops out. What would you recommend? I'm thinking of going all metal 4 link inc. the steering. Thanks, Rob
-
salt water for about 2 weeks Rob
-
i had this problem with my scx10 and my hpi trophy. have you made sure the motor connectors are in properly? Rob
-
the rc4wd predator tracks are made for rock crawlers and trail truck. they are about 3 inch in height but you need the special adapters for the axle. i would try the intergy tracks. Rob
-
I recently bought an axial scx10 honcho. I have already replaced the servo with a savox wp and changed the rx and tx to a absima cr3p (wp) and the front bumper to a rc4wd tough armour. there is also rc4wd light bar and led lights. I am looking for a new ESC and motor combo which is waterproof and a full 4 link set aswell as a new steering link. Does anyone have any suggestions? i have looked at the Vanquish link set. Rob
-
What I mean is instead of normal steering rods they uses te dampers from something like a tt-01 or 02 and if set up right then this might cancel out the problem because it is more flexible
-
ive seen on some cars they have dampers instead of rods- maybe that might be a solution
-
if you want ill sell you mine, it all works and it is completely stock with some new parts
-
a: is it a truggy or buggy? b: how many cells are you running c: when you turn it on does the motor make the 3 start noises 9 if you know what i mean) d: if you are using the stock tx are the batteries fresh e: (i found this with mine) are the rx wires all plugged in right way around and down far enough hope this helps Rob
-
is there an age limit on the seller
-
on msuk forum how do i add picture so that i can sell my trophy thanks Rob
-
I want to sell my HPI Trophy truggy flux but i don't know where to sell it to get the best price possible. i'm also debating weather to sell it as a roller or rtr. please help Rob
-
For my new scx10 I was thinking of getting a new bodyshell for it but didn't know if the pro line ford raptor body for the emax would fit Thanks Rob
-
good place to start. i've got the truggy version. just be carfull on the trigger when starting and if you don't wan to use 2 lipo's then get at least a 3s and a deans loop. http://www.modelsport.co.uk/hpi-trophy-buggy-flux-2.4ghz/rc-car-products/39700
-
-
does it matter if the case has massive hole which is 'professionally' covered in gaffa tape
-
i have a hardcase lipo and i was wandering if it was waterproof because i wanted to put into my scx10 any idea Rob
-
if you hammer your car too hard the crown gears (the bg one inside the diff casing will go flat and strip which is what happened to me
-
7.2v 4700mah