Wigglefish

Ok just realised my mistake with the servo i never install the grommets so it was the vibrating that kill it. Looking at the HS645MG as replacement.

Ok my trottle servo has stopped working, cant even hear an eletrical signal coming from it. Looks like i will have to order a new one, has anyone got any ideas what one to go for as the last one was cheap dont mind speading a bit more. Budget would be around

Hi Tamiya cowboy, Yes trottle servo response to commands with the failsafe attached, i have a red light flashing meaning all is ok with the battery voltage. Solid red light means low voltage. My old failsafe was red black and white, new one is brown red orange its a GV 100 i think. I go the set it by switching on transmitter and then receiver apply breaks and press the set button on the failsafe. When i go to test if it has worked by switching of my transmitter the throttle servo jumps to full open. I will try to post vid later today.

Ok really confused , i recently crashed my nitro buggy and had to rebuild a few parts, suspension and throttle servo. Installed new servo hitec HS 311 and all looked ok working fine. Went and attach my failsafe but no matter what i try i cant get it to set. Though it might be faulty so bought a new one and the same thing is happing. Has anyone got any ideas what it could be, really want to get out for a run with it but cant until i sort out this issue.

Standalone RC SKY, have ordered a new one. Hope this will sort it.

Looking good

Recently had a spectacular failure with my nitro and have been rebuilding it since. Almost up and running again but no matter want i do i cant get my failsafe to set and ideas?

Its a bit of a learning curve when it comes to nitro but its worth it. What model do you have?

Yes check the drive shaft as the grub screw might be missing. If you have a 4 wheel drive you should have two of these one at each end.

@ super sharp shooter That worked thanks again.

Sorry in work at the moment. Will confirm when i get home but i think you are spot on will let you know later thanks again for your help.

Great news was getting worried, thought i had the servo on the wrong way lol. Thanks so much for your replies

A very basic one Hobbypower 2CH 2.4GHz GT-3 Sport Digital Proportional RC Transmitter

Thanks for the reply, newish to RC is there a switch on the transmitter to do this?

Hi all, Just installed a new throttle servo after the last one failed on me. But it seems that the controls are now opposite (acceleration on trans is brake on receiver) i have checked my servo connections and all appears correct. Can one tell me what im doing wrong?

Thank Alex97

M05 long wheel base

200mm, might have to give the paint a go so. Just thought there would be a website in the uk/Ireland I could buy one from.

Anything that fits the M05 chasis not to pushed on what shell exactly. Once it pre painted ill be happy.

Morning Guys Does anyone know were i could purchase a pre painted body shell for an M05?

2's it is then thanks Guy's

Im glad I asked you guys I was way off with what I was looking at. Would you run 2's or 3's

Yep cool was looking at this http://www.modelsport.co.uk/modelsport-uk-blast-2-bl-10.5-brushless-system/rc-car-products/375362 ?

Hi Guys looking to update my M05 to brushless have already installed the reinforced gears but cant decide which brushless would best suit chassis please help.

Few more pic