boaterxx

Do you have a roller remaining?

Cheers butcher, the inner bearing is standard'ish size 5x10x4 I think. The outer bearing is smaller in width and outer dia. It could be 5x8x2.5. i'm away at the moment so have no access to measure the old ones and don't want to buy bearings I have no use for.

Can anyone help? i am rebuilding a ts4n 2 speed for my nephew and would like to know the bearing sizes for the clutch bell so I can order while I'm away. The bell is the full threaded type complete with anodised pinion gears. I have noticed that the inner and outer bearings are different sizes. Any help would be appreciated.

I need some advice. I am new to electrics and crawling, been running 1/5 scale 5 T's for a while. I bought an AX 10 6 months ago and got the bug. I have just ordered a Gmade R1 and wondered if there were pinions supplied? I have a Novak crusher and Ballistic brushless 21.5T to go in and will be running 2s lipo. also on order is the front battery /servo plate and delrin skid plate. What would be a good starting point for pinion size? I would like the same sort of speed that my AX 10 has. That is fitted with a 55t brushed motor but unsure of the pinion size. Any help and a dice would be appreciated.

Thanks lads, Been looking at the Hitec's . I only have an Apple pc so the pc based programmers are out. But there is a stand alone programmer from Hitec (HFP 25). Any good???? What about the Hitec HS 7950 TH servo's ???? I would like a bullet proof set up as I am a long way away from any decent suppliers and to get stuffed shipped over brings a 65% tax from the Philippine customs, B******'S. I usually get everything in the UK on my quarterly visits then take it all over.

I'm new to large scale with my Losi 5t and after 10 tanks running time and 2 new steering servo's i want to make some upgrades to steering system. I have ordered a GFR dual steering radio tray and some time in the next few weeks i will be ordering a Killer rc 7.4v LiPo and Darksoul direct power steering harness. when funds allow i want to get a trio of multiplex Rhino HV pro's or the savox equivalent HV Digital servo's and a superbee kill switch system. Can anyone give me a little guidance on the following. I am using a Spektrum DX3 S transmitter and the stock Spektrum Rx. Do I need to change the frame rate on the radio for the digital servo's? What sub trim values (ballpark Figures) would i need for the steering. Would the sub-trim values be the same as the stock Losi setup for the throttle / brake with the new digital servo? Any help or guidance would be greatly appreciated.

Cheers lads. I'm away at work at the moment and i can't remember what motor and esc thats fitted I think it's a novak motor but not sure what type.

I'm new to electric models and was wondering if its possible to change over to LiPO batteries for my AX10. I already have a charger that will do the job, but are there any modifications that will be needed to run LiPo batteries. Any advice would be apreciated.

Digimon, Still interested but away until after crimbo. Boater xx

Hi, I am interested, but not in the uk until 23rd or 24th November.