Echlin W

I photographed the bottom end well, There was 8-10 photos taken with a Galaxy S5. I did not misinform you, yes their are superficial scratches as I told you clearly. These insignificant scratches do not prevent the engine from running or sealing perfectly. I stand by the bottom end as it has run and sealed perfectly through rebuilds with these superficial scratches. This bottom end is absolutely fit for use. You do not deserve a refund here. We'll have to let Paypal decide, but that is my position. Echlin

Please re-read this. That is a serious insult Harvey, I answered honestly. To say i've no defensible position here is the same as saying you have no defensible position here. I stand by the bottom end as it has ran and sealed well through rebuilds. Thanks

Hello there people , Im the seller. I must speak up here as it's been very one sided here. I feel i'm not in the wrong here, as the engine seals and works perfectly. ----------------------------- Harvey, The scratches are superficial. The engine has been serviced throughout its life, and has had no problem with mating surfaces between each service. (No air leaks). I did not mislead you, I told you about the insignificant marks. If you would like to make these less visible use some very fine polishing/sand paper. But ultimately this isn't required. Just advice. The remedial machine work you mentioned is obviously not necessary. The engine is as shown in photos and as described. Also rebuilt with Nachi 6001 C3 bearings and NTK seals. The bottom end is ready for use, there is not a valid reason for a refund here. Echlin

Bump for Savox 1256TG reductions

Sold :), Mods please lock

Pm'd :), Its a Rpm rear bumper _____________________ Bump

Bump for big price reduction

Bump

Been pm'ing Carp, we haven't agreed on a price yet Bump reduction

Hello Savox 1256tg £48 ono HS-5755MG Servo £38 ono

Bump

Heya carp! About 80-90 tanks, it used to have a head ported by Yamadude. Mating surface has superficial little scratches from taking off an old gasket, it seals perfectly of course. Nachi 6001 C3 bearings and NTK seals were used when I rebuilt it. The reed petals haven't been changed. They're good, no cracks and close fully. I came to that price because the only place I can find selling them is bajaland.de for €349.99 (295 pounds) and that's without any crank. Bearing in mind that they aren't even in stock, and how hard it is to get TS cases. If you use this bottom end and the ESP head from DDM you a top of the range TS long block for £345 (Before negotiating with me on price) Its £165 or nearest offer so feel free to barter a little

Selling my Trevor Simpson Reedcase 4-Bolt bottom end. Has a very tidy mesh mod as standard. Rebuilt 10-15 tanks ago, ready for a ported head of your choosing. Nachi 6001 C3 bearings and NTK seals were used when I rebuilt it. For example this one: EarthSurfer 30.5 TS 4-Bolt. A beast. Engine will drop right in to your baja. I'm saddened to sell it but getting out of r'cs for a while. £165ono NOW £140ono NOW£130ono

Hostile 56T's, TGN filter, and all beadlocks sold. Bump

Pm'd :), Will do £38 delivered. All parts new