AlexBruv

Is this the stock pinion? http://www.modelsport.co.uk/ansmann-racing-pinion-22-tooth-master-smacker/rc-car-products/37209 If so you can choose ANY 0.6mod pinion - =647]http://www.modelsport.co.uk/mod-0.6/rc-car-categories/9920/992050&MSAttributeID[41]=647 But i would get 2/3 pinions, so go for a 24/5/6 .... or just get one for now. They will all make a tiny bit of difference in speed, but you will notice it..

Defo looks like it!

The new Argus A5 5+2 port bump start .21 w/ exhaust? http://www.jespares.com/nitro-models?page=shop.product_details&flypage=flypage.tpl&product_id=12912&category_id=264

*Awaits the wrath of le panda to strike on the idiotic people of RC*

Shaun, if you get a lift, message me as i think i will need a lift, i will pay fuel money!

- First off, you say it's hardly used? has it even been run in? if not take a peek on the stickies in the nitro section, they will tell all you need to know. - Did you prime the engine? - The glow start may have started to go flat, nimh and nicd don't like to be left once charged. - Does the glow plug work? - Once you have done the above, then reset the needles back to stock do another once over of the above and start from there.... Also, it might be warm and dry by the ambient temperature might not be enough to get it going, so get a hair dryer out and see how it goes

Nope they will be fine, digital and analog servos work fine with 27/40mhz and all 2/4ghz tx/rx sets

+1 ... you Cannot fault turnigy for the price, top quality packs!!

http://www.rcuniverse.com/forum/m_7064176/tm.htm There you go mate, was at the nuremberg toy fair!!!

You should be okay, i left my rascal for well over a year before starting and that ran.... Just get yourself an OS#8 glow plug and some 20-25% fuel... grab some after run oil, re oil your foam air filter, set the needles back to stock and go from there... Just check the basics

.. *runs*

It would be, sintered rotor, and ballraced (bearings) ... i think a sintered rotor is supposed to be better because of how it's made.

Could do, depends what i'm doing... see what others say

so thetford this weekend.. what day?

Naws foreveralone.jpg

Just grab yourself a nice Turnigy Nano-Tech from hobbyking, Get this, http://www.hobbyking..._Lipo_Pack.html or for slghtly less money and a bit less C rating, http://www.hobbyking..._Lipo_Pack.html. It isn't necessary for a hardcase, but if you want a battery that doesn't come with a case around it, just make one, just wrap in a nice layer of bubble wrap or cut and old video case and put it into that... be creative

castle get so many products back to repair, don't you think they should re think something?

I Should dont hold me to this one, have a 3s by next weekend.... if not it'll be mad rat only

Well i should be able to go next week, so thats 2 people if weather is good

Ordered a 3S lipo for the mini st

Any one going next week or week after?

My turnigy accucell did this after only a few charges too, and my lipos where both at 7.85v (ish) before i charged them (checked with a volt meter) so it could be a dodgy charger