Minnsy229

Just been through all of the points raised and at the end of settings the high points it still continually blinks red and will not store the settings. I tried the throttle in normal and reverse when running this test too and it is just not working for some reason. Could it be a fault with the ESC?

Also, if I need to set all the trim knobs to zero, how do I reset these? As I assume I may have set the car up with these out of place? If that is the case would I need to re-bind the servo? What is best to tackle this? Because when I set them back to zero the steering is hard left so they must be out of line. Thanks again everyone, and happy new year.

Thanks for all the messages guys. So this is the picture I took of the transmitter when I was setting it up. So you think I should put the right hand switch to the reverse setting and try the set up process again? The weird thing is the fact that no matter what I do the ESC is refusing to store the throttle/reverse. Would this cause that same issue? I followed a few YouTube videos and only used the channel 1 and 2 for the ESC and servo. Am I right to assume it can’t be a binding issue if the steering is working?

Hi there I just purchased a Tamiya rising fighter kit and have some set up problems I hoped someone may be able to help me with. I managed to bind my controller with the car, however all I have is steering function and no throttle. However when I move the throttle trim dial I can work the throttle that way, but nothing from the trigger. I have stored the setting for brushed motor, however when I go through the high point set up when I try to store my throttle/reverse via the ESC it doesn’t store them and just continues to flash red instead of turning off. any ideas? The transmitter is an Absima CR2S.V2 with a TBLE-04S ESC and Absima R3FS receiver. Steve

Hi there I have this very same problem and hoped someone may be able to help. I managed to bind my controller with the car, however all I have is steering function and no throttle. However when I move the throttle trim dial I can work the throttle that way, but nothing from the trigger. I have stored the setting for brushed motor, however when I go through the high point set up when I try to store my throttle/reverse via the ESC it doesn’t store them and just continues to flash red instead of turning off. any ideas? The transmitter is an Absima CR2S.V2 with a TBLE-04S ESC and Absima R3FS receiver. Steve