cgb1234

Gettin the filter off the carb is a pain due to the tie holding the filter onto the carb.I dont want to cut the filter tube.Is there a easy way to get the filter off the carb or will i have to cut the tie?

Dont really fancy taken it apart.So can i just flush it with wd40 and do i spray down the glow plug hole?

Hi all, is there a way you can flush the engine out to clean it etc.What solution could you use if at all possible and are they easy to take apart and re assemble? Thanks in advance.

My mate used a Dremel on it! Sorted!

Yeah thats the problem (

Might be a bit difficult as the screw is flush with the surface it is screwd into.

Hi, I have rounded off a alan key screw and wanting to know the best way to get the screw out plz.

thanks.

Even though my reciever is only 2 channel and the transmitter is 3 channel? Will this be a problem?

Hi, Just wanting to know if this transmitter HPI TF-4 Transmitter w/o Crystal (3ch/AM27MHz) is compatible with the stock reciever on the hyper 7?

Did not screw the pullstart on tight enough and when i ran the car pullstart came off, but worst still the spring uncoiled ( ARRRRRRGGHH).So i guess that is that!

Just attached a new pullstart to my hyper 21 engine as the cord snapped on my previous one.The problem i am having is when i pull the cord out it does not return to its base.Am i overtightening it? because if i loosen the four screws that attach it to the engine then it returns.Or have i missed something?

cheers!

That would make sense im fitting to hyper 7!

ok thanx:)