shefbiker

Rears are 93mm extended and 65mm compressed. Front are 75mm or 59mm. They are 1/10th scale, from a tc02c.

Do you want fully extended dimensions? Or fully compressed?

i have four sets of aluminium team c shocks for sale. £15 a set, posted. Used but in good order.

I'm after a TC02C buggy if anyone has one.. Ta

Hi. I have a xc550tf-mj esc, and i was wondering whether anyone has any experience of programming them? When I go into the setting mode, it bleeps 5 times, and then bleeps once, then twice, then three times, then four times, and then five times. I understand that this is indicating that the ESC is set to setting five of five, but in the manual there are only four possible settings. I would be grateful of any advice that you may be able to offer. Thank you Tim

I have a compressor but nothing else... Does anyone have any other airbrush gear for sale? Sent from my XT1032 using Tapatalk

Sorted now. Thanks Sent from my XT1032 using Tapatalk

Has anyone upgraded the nylon bushings in the steering linkages and pivot posts to ball bearings on an X1X? Any tips? Sent from my XT1032 using Tapatalk

http://www.nwnitro.co.uk/

Have you been to the new North West Nitro nr Blackpool?

Hi. Yep. Yep. I bought them and they do nicely behind the flywheel. I also bought these as a banker which have pretty much everything you need... http://www.rccarshop.co.uk/index.php/anscs1001-answer-rc-clutch-shim-set.html

Ta. I actually found dedicated flywheel shims at MB Models. Sorted. Thanks for your help.

I've changed my engine and need to shim between the main engine bearing and the flywheel collet. What do people use? Regular M5 stainless washers? They're about 0.8mm thick, but probably accurate enough... I'll need a few anyway... Thanks

Does anyone know whether I can get a 125cc fuel tank for a Hong nor x1x? The stock one is 150cc, so not BRCA compliant... Ta

Nice one chaps. Ta.

I've got 2 buggies...an inferno neo 2 and a Hong nor x1x. I'm trying to decide which one I should bother improving for my son to use... My gut feeling is that the Hong nor is the better chassis, but would appreciate advice. Thanks

Does anyone have any suggestions for engine mounts that don't cost the earth? Need to install an RB S9...

Thanks. Blimey. $60! Are there any more cost effective solutions?

This is doubtless a stupid question, but I'm putting a new engine in my inferno neo, and I suspect that I will need some engine mounts. The stock engine bolts direct to the chassis, whereas the new RB engine mounts via tabs from looking at the instructions... Where do I get engine mounts from? Are they engine specific or are they adjustable by shimming etc? Advice would be appreciated... Thank you

Thanks. Is it 3 or 4 shoe? A clutch bell would be good...

I'm after a flywheel tool and puller if anyone has one...

I'm after a tuned pipe for an RB S9 engine if anyone had one...

I'm after a 1/8 racing clutch for an RB engine... Anyone got one?

Please forgive my ignorance here... Since my pull start has snapped and I now use a starter box, is it worth putting sealant around the hex head shaft that pokes through the one way bearing? Presumably there is no need for this to turn now I don't use the pull start?

Do you also put sealant under the cylinder head?