liamb2387
-
Posts
223 -
Joined
-
Last visited
Content Type
Profiles
Forums
Prizes
MSUK-Forum - RC Model News and Community
Articles
Events
Posts posted by liamb2387
-
-
Turned out to be a dodgy motor!
-
I don't but the one I'm using is brand new
-
Tried a 3s - no difference
Sent from my Nexus 5 using Tapatalk -
Could the problem be that I'm only using a 2s lipo until my 3s arrives?
-
Cheers for the suggestions
-
So your saying it should be ok as it is?
-
I'm sure the minimum is 1000 and max is 2000!
Sent from my Nexus 5 using Tapatalk -
Wonder if it's something to do with the transmitter
-
Nope. Not been in the air yet
Sent from my Nexus 5 using Tapatalk -
I'll take a look. Anything else it could be?
I tried to calibrate the escs but I didn't get any beeps to confirm it had worked -
-
No, just the firmware it automatically gives you. How would I pick another version?
-
I have yeah. Repeatedly gone through the full setup wizard. mainly out of frustration
Sent from my Nexus 5 using Tapatalk -
Hi.
Anyone have any experience with the arducopter fc's?
Problem im having is that everything thing seems to be set up right. The drone arms but the motors won't spin!
Any help?
-
You definitely adjusting the right thing?
Normally similar to the twisty bit on a radiator
-
60 is too high for a blow gun. Max pressure on mine is 30 I think. Try that
Sent from my Nexus 5 using Tapatalk
-
Or could be opposite to what Danny suggested...is the reg psi set too high for the blow gun?
-
Sounds strange because if the tank really is full it should take a little while until it's empty and you'd hear the air escaping
Sent from my Nexus 5 using Tapatalk
-
Is the little brass screw at the bottom of the compressor closed?
-
Raspberry pi 3
-
Pm'd
Sent from my Nexus 5 using Tapatalk
-
Cheers for the suggestions. So should I stay away from the team Orion one?
Sent from my Nexus 5 using Tapatalk
-
Don't really understand charge rates if I'm honest
Sent from my Nexus 5 using Tapatalk
-
Not a massive lipo user and not likely to ever be. Couple of 3s and 4s lipos for my drone - around 2300mah and a couple of 2s receiver packs for my nitro buggy. Couple of 12v leisure batteries and then the usual NIMH and nicads
Sent from my Nexus 5 using Tapatalk
Naza m lite setup tips
in Drones / Multi-Rotors
Posted
Hi.
Anyone have any tips on setting up the above flight controller. I have just acquired a dji 450 and it seems to be flying ok but it does pull to the right and doesn't hold it position that well.
I have calibrated the gps, made sure the quad has a good centre of gravity and checked the trims on the Rx.
Anything else I could try for a more stable flight?
Also, has anyone recently upgraded the naza m lite to v2 firmware? I tried this just the other day and it didn't work. I wondered if dji had possible cracked down on it.