nighstalker

what engine is it mate?

might do but want it to last at least a 2 months lol

Best place for parts is midland helicopters, some parts are not cheap http://www.modelhelicopters.co.uk/helicopter-spares/standard-spares/hirobo.html

All lipos when fully chargered will be higher, so as long as your balance charging you will be fine, the charger will keep an eye on it but just keep eye on it

Thing is he dont know about it yet lol, My kids stay we me every other weekend and since last saw him iv managed to get hold of this but wanted it running right ready for him, I have a EB4 S2.5 so now we can race each other but hes has a bigger engine "bugger" lol

Cheers Mini-z-awd, just reset all the needles again and used 2 screw drivers one on each screw and managed to get it ticking over perfectly thank you

the whole car was a complete mess and well bashed lol,

I have done that, its the first thing i did when i got the car was take the engine out and strip it down and clean it,

I have Mid needle on my heli engines but never seen it more while im screwing the LSN lol. will try it with 2 screw drivers thank you

Hi all Wonder if anyone can help please. I picked up a Hyper 7 complete for my son (2nd hand) I reset the needles to Factory settings because i don't know what the last owner used for fuel. In the manual it states HSN 3 1/2 turns out and the LSN 2 turns out. But there is a 2nd screw thats on the end by the fuel inlet is, Now i have set this flush and turn the LSN all the way in, Now as i wind the LSN out the Screw that's below the fuel inlet winds its self in at the same time and if i wind that screw back out the LSN changes as well So for the life of me i can`t get this beast to run right, it starts straight away but give it a quick burst of throttle she shoots off then stalls. There is no reference in the manual for this other screw, but found a manual for a Hyper .21 and its the same carb and it has ref to this screw http://ofna.com/pdf/eng-hyper21.pdf Any one got any ideas?? thanks chaps steve

same as always 11am? i like my layins lol will be me only (maybe mrs) dont have kids that weekend

Il be coming

what make of RX is it?

you should be fine but your range might be a little shorter, but with Model cars we dont tend to drive them far away from us, when your next out with it do a rang test first

Hi anyone got a New Ho-Bao Hyper Starter Box Rubber Wheel they no longer want?? cheers steve

I have a EB4 S2.5 mine goes like stink and runs very well and loving it

so when next? lol got to keep these bash days going

I have just put a HS 625MG in my hyper 7 for my boy, good servo and does the job and cheap, you just need a standerd size servo http://alshobbies.co...ock.php?pc=3141

lol

I could see him doing this lol

I found a broom handle so we can strap my gopro and get some up close video of cars taking flight lol

Lol he needs to get used to it first of all before braking it

Thanks, but onces he finds out how fast it goes he will go for it lol, i might make a ramp thats not so sharp upwards just so he can get used to jumping with a more powerful car

i like the idea of seeing how much air can get. its the point of 1st jump could be its last,

i enjoy cleaning it gives me chance to check over and make sure all is ok, Don't encourage him to smash it up lol