Leo Best

4 Fastrax Eagle Truggy Tyres for 1/8 scale truggy's. These are on road tyres. They are used but have a good amount of tread left. Two of the tyres have slightly less tread. The wheels have a few scratches on them and on two of the wheels the tyres have come unglued a bit but this could be re glued. Please see pictures. These will fit most 1/8 truggy's with a 17mm hex. £14 including postage. Paypal preferred.

Bump

Parts for HPI Q32 RC car. These are all unused, new items except for the tyres which are used. They are from spares I bought but which I didn't need. Included: 3 X chassis sets minus bottom chassis #114289 1 X plastic parts set #114290 2 X rear wheels and 1 front wheel #114276 5 X chassis set screws for adjusting turning radius 1 X Allen key for set screws Price: £9.99 including postage.

I reckon holes in the tyres only would be best. Holes in the wheels tend to let water in and soak the foam. If there are holes in the tyres then the water can be mostly spun out and the foam can still compress. Sent from my Pixel using Tapatalk

They look quite good actually. Sometimes white wheels look a bit cheap though. Wonder if they would look better in black? Sent from my Pixel using Tapatalk

I haven't done much soldering but I could probably do that. I have bought a new motor to try to see if the motor is worn out. If the new motor isn't faster then I'll swap the wires.

The motor uses a mini connector which can only be plugged in one way. Tried the throttle reverse but it just reversed the throttle even after re binding. Sent from my iPad using Tapatalk

Bump

Bump

Sold now.

Traxxas #2948 2-3 cell iD LiPo balance charger. Removed from Traxxas Aton. Charge rate 3 amps. In very good condition. It has been used about a dozen times. £12.99 including postage. Paypal preferred.

bump

Bump

Ok, thanks for your offer though

Not really. I have just bought a new car so need the money really. Depends what you have, a LiPo battery maybe?

It is a brushed motor. The ESC is an ESC/receiver combined unit and as far as I can see in the manual it can't be programmed at all. Sent from my Pixel using Tapatalk

Recently bought a maverick ion xt. It's second hand but was in very good condition and the seller said it had only been used on christmas day. It goes much faster in reverse than it does forwards though, I have tried re-binding the tx/rx and have also tried the throttle reverse switch and throttle trigger position switch i.e 50/50 or 70/30. I contacted HPI and they suggested that the motor brushes might be worn out in forwards direction more than revrerse since forwards is used primarily. Could this be possible? Any advice would be appreciated before I buy a new motor.

HPI Blitz 1/10 rolling chassis. No electronics included, will require motor/ESC, transmitter/receiver and servo in order to run. Price is £59.99. Postage £12.00. Paypal preferred please. The car is in used condition and has scratches on the bottom of the chassis and a-arms but has been well maintained and drives well. Includes some spare parts which have been opened and are not complete. Also includes spare bearings for front and rear wheel hubs and gearbox as well as a 22 tooth pinion gear to go with the 88 tooth spur gear. Upgrades include: - HPI performance aluminium steering rack set £60.79 - HPI aluminium shock caps £14.99 - HB aluminium servo horn 25t £9.96 - RPM front a-arms - RPM rear a-arms - RPM rear bearing carriers Parts installed on car - Pro-Line Flo-Tek Ford F150 bodyshell - Fastrax eagle sc tyres X4 Spare parts included: Item Price new 100317 shock cap and preload collar set £4.73 A838 flange pipe £5.93 103364 bumper shaft £7.35 Z892 washers £4.28 Traxxas 3647 £4.28 86882 suspension shaft 3x32mm £4.73 86969 thumbscrew £4.73 104726 silicone o-ring 5x9x2mm £5.93 6819 silicone o-ring red £2.61 Z242 e-clips 2mm £2.14 85054 shock body set front 87mm £4.73 100311 front upright set £9.03 100311 front upright set £9.03 100311 front upright set £9.03 100314 suspension mount set £9.03 103328 skid plate set £16.63 103327 body mount set £13.28 Total £117.47

You might want one of these as well. https://www.rcbearings.co.uk/625zz Not quite sure whether both bearings are the same size. If not this is the other one I ordered. I think the end cap bearing is larger.

I bought bearings for a hobbywing motor that is very similar. Hobbywing make the Flux motors for HPI. https://www.rcbearings.co.uk/index.php?route=product/product&product_id=14&search=695zz I buy all my RC bearings from this website. Very good prices and the bearings are good quality.

bump

bump

I used a PayPal fee calculator and the fee would be £1.05 and the postage is included in the price.

Sorry. I would like more than that for it they are £45 new.

HPI EMH-3S brushless ESC. Used condition, has some scratches on the bottom of the case and the sticker is a bit worn, works perfectly and I have recently cleaned the heatsink and fan. It has an XT-60 connector fitted. Can run 2-3S lipo or NIMH batteries and is capable of 80 amps continuous. Ideal for 1/10th scale cars. £25 including postage Paypal preferred