garthy22

http://www.ebay.co.uk/itm/Baja-5b-SS-1-5-Complete-and-Ready-to-Run-29cc-New-Body-Shell-/181690541997?ssPageName=STRK:MESE:IT King Motor (HPI Clone) Baja 5b SS - 1/5 Scale - 29cc This is my beloved Baja 5b Buggy, up for sale as I simply don't have the space for it any more. This is the King Motor Baja which is an exact clone of the HPI Baja 5b SS in both looks and quality, complete with the orange anodised parts typical of the SS Super Sport. It has a 29cc two stroke engine fitted, which is actually a higher capacity than the one normally found in the SS model, and is very fast. I have only run this buggy a maximum of four time since rebuilding it and it has proven itself to be very reliable and a lot of fun. My son loves it! As part of the rebuild I have fitted a replacement body shell and this is brand new, as you can see from the photos. It also comes complete with all radio equipment, including the Transmitter which seems to be a re-branded Fly-Sky FS-GT3B, which is a really nice handset to use, with a lot of available functions. Rechargeable receiver pack is also fitted and also comes with a mains charger for this. Also have a spare spark plug which I'll include. Local Pick-Up of this model is available and is preferred due to the sheer size of the model, but I will also post within the UK. Please Note: There will be no petrol supplied with the Model. As a few people have been enquiring, I expect the cost for shipping would be about

Barely Used: Turnigy 4WD Mini Rally - Extreme Edition ARR Bind and Drive http://www.ebay.co.uk/itm/Turnigy-4WD-Mini-Rally-Extreme-Edition-ARR-Bind-and-Drive-CW-Batteries-/171664898864?ssPageName=STRK:MESE:IT Bought this a few months ago but have hardly used it since its purchase and so I am therefore selling it. Comes with a 2s and 3s Lipo, and a Hobby King HK-3000 3ch 2.4ghz FHSS Receiver (check compatibility, or install your own Receiver) Really quick little car, great fun, especially on 3s. Please remember this auction is for the car, receiver and batteries only, you must provide your own transmitter and charger.

http://www.ebay.co.uk/itm/Quadcopter-DeadCat-Alien-X450-Spektrum-DX6i-KK-2-1-5-1100kv-3S-Lipo-Spares-/181575589260?ssPageName=STRK:MESE:IT

http://www.ebay.co.uk/itm/Quadcopter-DeadCat-Alien-X450-Spektrum-DX6i-KK-2-1-5-1100kv-3S-Lipo-Spares-/181575589260?ssPageName=STRK:MESE:IT For Sale: DeadCat / Alien X450 Quadcopter with everything needed to start flying Dead Cat/Alien X450 450mm size Quadcopter. Nice size frame, plenty of room for expansion 4 x NTM Prop Drive 28-26s 1100kv Brushless Outrunner Motors (New) Q-Brain 4in1 25A Quadcopter Brushless ESC 2-4s Lipo (New) Spektrum DX6i 2.4GHz DSMX Programmable Transmitter (New) Spektrum AR6200 Microlite Receiver (Dual Link) (New) KK2.1.5 Multi-rotor LCD Flight Controller Board with 6050MPU and AMtel 644PA (New) Hard Case enclosure for KK2.1.5 Flight Controller (New) 2 x 2200 mah 3s (11.1v) Lipo Battery Packs with XT60 Connectors (used for a few flights only) Ripmax Sigma EQ Mini Balance Charger (1 - 4s) (not shown in picture) (used but very good condition) LED Marker Lights on each arm for orientation 4 x Spare Arms (2 x new red, 2 x used white)

X230 Mini Quadcopter, fully built with Brushless Motors, Brushless Speed Controllers, Multiwii 328p Flight Controller, FlySky Six Channel Radio and one 3s 11.1v 1500 LiPo Battery. Also has a couple of spare props (uses 5 x 3 tri blade props). Bought the parts new as a project quite recently but just can't seem to find the time to configure and program it and cant foresee having much time to use it unfortunately. The Quadcopter has not yet been flown. Frame has been built in a slightly different configuration to the original spec to make it more stable, and has had the original motors replaced as one of them was delivered faulty. Flight controller will need programming and calibrating before being ready for flight, please ensure you are familiar with this procedure.

http://www.ebay.co.uk/itm/171176978618?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1586.l2649 Schumacher Supastox 1s Shorty. Fully built with the following: Uprated Alturn USA Low Profile Servo SpeedPassion 13.5t Sensored Brushless Motor Core RC Pace-45R Brushless Speed Control Schumacher Alloy Ball Diff (With Tungsten Carbide Diff Balls fitted, super smooth) Absydian Racing Carbon Battery Strap Type F Body Shell, Professional one-off paint job by C-Star Paint http://cstarpaint.wix.com/rc 3 x Lipo Batteries: 1 x Core RC 3200mAh Pack, 1 x Nano Tech 5600mAh Pack and 1 x Nano Tech A-Spec 6000mAh Pack (Not Pictured) Spare set of (used) Contact wheels Few spare bits such as springs, ESC fan, Rear body mount Please note that although a receiver is shown in the photos this is NOT included in the sale. You will need to provide your own receiver / transmitter and charger. This car is in fantastic condition and has only been raced a handful of times. Unfortunately I am finding it hard to devote time to this and so would like to see it go to somebody who will enjoy it as much as I have.

Its an auction.....

http://www.ebay.co.uk/itm/171175333472?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1586.l2649 1/10 Sakura Zero S Brushless touring car. Includes steering servo, 8.5t brushless motor (re-branded orion motor), 120a Brushless speed controller (re-branded hobbywing xe run unit) and usb speed control programmer. You would need your own receiver, lipos, shell. Car needs a new spur gear (if I find one I will include with the car). About 6 months old, used by my son. Has some scratching to underside of chassis due to outside use, but a very nice car. Due to the nature of this hobby, returns,are not accepted.