greekbullet

Hubsan arrived today... and now trying to set it up lol

Looks more less the same but it has facy :LCD on the remote lol ... wouldnt mind an LCD I know it is going to be useless lol

Cool so the difference with mode 1 and 2 are known now I think I prefer acc on the left. Thaks for replies guys Has anyone flown one of these before? seems like only the hobbyking to stock them Seems rather cheap for 3D heli. Ordered a quad heli should arrive today just for fooling about, a Hubsan X4 Quad Copter But I would like to get a "proper small heli to replace my bashed one" lol Don't want to move to larger moving things before I do some exersice first.

Is this still available?

Hello guys, I was just looking at HK, and found this Turnigy FBL100 3D Micro Helicopter (RTF) (Mode 2) I do not know that the mode 1 and mode 2 difference is to be honest. Has anyone tried it? I am fed up trying to find parts to fix my cheap 4ch gyro I have ... which to be honest is not the best cost me almost

Doh ... sorted it, I think I am getting old and forget things lol I sprayed a bit of IPA and rinsed off any potential oil ... and then adjusted the linkage, I was looking the throttle linkage, not the break linkage on the other end. I just realised it. I adjusted it and it is much much better!! must be the nut has slid off over time. Cheers

I did try to adjust the linkage ... form the servo side.. but did not help. I run a whole tank of it ... with the brakes on incase it burns it off ... but no improvement. I will do some more cleaning up tomorrow I think and see what happens. If not then I will need to get new brake I guess.

I did the check the throttle trim and also when I switch it off goes on auto brake but this does not seem enough I tried adjusting it manually on the servo too :(

After being way to busy with work the last year ... my bullet has been gathering dust on top of the wardrobe! I ordered earlier in the week from Modelsport silicone oil to top up the shocks as I have never done it since I bought the car, it was sitting low in the front ... so got a 40wt ... hoping it will be OK. It did brilliant job now sits in the correct height not sinking as soon as the wheels touch the ground. Seems a bit more bumpy though must be the wt of the oil I guess. Could not find out what it had from the factory. I took the chance and ordered a water resistant air filter too that comes with the 2.4GHz bullet :) A bit of after run oil in the engine before I fire it up and also checked the glow plug (still the original on the car lol) and checked everything else and seems to be working brlilliant took it out for a test run. My problem is that the brake doesn't seem to be enough :( it kind of works like 10% of its performance not enough to stop the car from moving in idle! so not working. I think it has WD40 from previous clean ups when I took the car in the snow ... or something else on the pads... If I use auto brake cleaner will it be OK or will I make it worse? This should clear any oily residues. Any suggestions?

They do look the business.... I ill stick with the stock ones lol for now, well if I have time ... now the snow got harder I will take it out tomorrow and do a second attempt and film lt. It is good fun though ... love it :)

well I attempted for the snow although it was too deep lol ... will take it out tomorrow and hopfully will be better