mishking

Right i have re-adjusted hsn,lsn and idle back to factory default and it seems to be a hell of a lot better. Wheels move only a little bit at idle now.

Update: Have been playing with car today after buying a starter kit and some 20% fuel. I can start car easy with the roto start but the car just revs all the way up and the wheels spin flat out. Anyone have any suggestions to what might be wrong? Regards, Greg

Looks like there is a shop near me so i might pop down on the weekend and have a butchers.

My blata elite rep is a savage bike, it so light and very difficult not to lift the front end coming out the corner at full throttle. All good fun. It's a shame about the typical cag quality. Im on the lookout for polini 6.1 lc engine to start my new project but i keep missing them when they go up for sale. Back on topic. Not knowing much about nitro would it be better to run a 16% nitro mix or should i go higher? Im going to start with the base carb settings that CEN recommend for the NT-16 engine and then start to tweak from there. Once ive got it all up and running il post up some pics and vids. Cheers, Greg

Ive had loads of mini motos over the years but at the moment i have got a b1r with a 50cc big bore kit, 19mm carby and a 3 shoe clutch and performance exhaust. Put's out nearly 11bhp at the wheel!!!. And ive also got a standard Blata elite replica. Thanks for the advice R46. Regards, Greg

Hi, New to Nitro Cars but have been around racing 2 stoke engines for years, mini moto's etc.... I have brought a CEN TR4 from ebay as a non runner with the intention of getting it back up and running if the engine has any decent form of compression, comes with loads of spares to. http://cgi.ebay.co.u...:EOIBSA:GB:1123 Are these cars any good? If the engine is worn out does any one know of a suitable replacement that will fit? Regards, Greg