FGBAJA

Hey everyone, I currently have 2 HPI Proceeds that I am making roadworthy, one has a slight crack in the diff casing right where the exhaust bar is fixed to the car. Does anyone know what type of plastic was used when making these cars? Regards Phill

Hay Everyone, I have a vintage HPI Proceed with a Hyper 21 (believed to be a : OFNA HYPER .21 8 PORT RACE Engine 1-8 BUGGY OFN53218) I'm trying to remove the flywheel and parts on the shaft! Any help on how to remove these parts will be much appreciated. Regards Phill

This is the combo I have: http://www.mtroniks.net/details1.asp/ProductID/625/MG2C.htm I have connected the 3 wires to the motor, It seems to work fine with all 4 wheels off the ground, but if I put it down it only seems to judder forward and backwards, any ideas? I noticed when I recieved the ESC, PITCARD and MOTOR that the capacitor for the ESC where missing. I have brought 3 x 100nF monolithic motor suppressor capacitors, are these the wrong ones? Thanks Phill

Hi Everyone I need advice please, I have just brought a Mtroniks G2 Pro motor and ESC off Ebay, Not that happy with it due to wires being a little melted (still connected - just plastic case) I know it was 2nd hand but no mention of this on was on the advert, also within the clear ish case of the ESC (SEALED) it seems to have melted - burnt from the inside!!!!! also no mension of this!!!! It came in original box with motor ESC and pit card rattling in the box!!!! NO WIRES!!!! Anyway to the point!!!! I am trying to see if it works correctly (have my doubts) I have managed to solder wires from old engine on to it (only 2) dont have the 3rd one, is it needed??? It only judders and beeps at me constantly, I guessing this is because 3rd wire missing? Also Advert said NO RETURNS so not happy any help to see if it works apprecated!!!!! Many thanks Phill

Thanks guys for all your input, Its a minefield to me!!!!! Still not sure they all look good to me!! Whats the charge times and 5c bit about ???

Hi Everyone I am by no means new to the RC scene as have been ivolved with them for years, I have now brought a electric buggy and feel a bit out of the loop with electric ones (normally run an Inferno nitro) I am on the hunt for my first Lipo charger combo, Im not sure about all the different ones on the market. Can anyone assist? I am kind of on a budget but am open to suggestions. What do all the different grades mean (5c ect) Cheers Phill

Hello all Could anyone please tell me what the correct gap is on the spark plug for the FG Baja? Also is the choke position down for ON? Thanks Phill

Power is getting to plug what should the gap be?

yes

took spark plug out and re-attached lead to plug ................... also tryed an alan key in the end!!!!!!! How is the spark plug powered

I dont think its getting power and the cars brand new

NO SPARK, would it be clearly visable?

My new Baja wont start?????????? plz help!!! Dont seem to be getting a spark? how is the sparkplug powered? Im new to petrol cars any advice/starting procedure help would be appreciated!! Cheers Phill

Hi there, I have just brought an FG Baja buggy and have now just got a Futaba S3306MG Large scale servo for the steering. It was supossibly brand new

Here are some pics, my servo according to MS is the right one!!!!!!!! Quarter scale!!!!!!! How is the spacer used as the servo is to short for the hole?