cew27
-
Posts
1,580 -
Joined
-
Last visited
Content Type
Profiles
Forums
Prizes
MSUK-Forum - RC Model News and Community
Articles
Events
Everything posted by cew27
-
i dont dare tamper with my xbox after it broke
-
this is open source softwaer
-
greeks aslo said greekstuff like ehgram makregh
-
josh it aint illegal i amnot selling adobe software
-
yes i did as they are going on ebay
-
yes but can u get all the necasary updates
-
yes all this is nice but anymore syggestions on hwta is worng wth me car
-
eeeerm i dont wanna risk anythin
-
all sold out
-
will do
-
mite it be that the glow plug isnt on tight enough so air is coming in through there
-
will do but even if the idle is too high it runs and then stalls and goes at maximum revs even with me holding it down the wheels are spinning
-
the idle is bout 3 mil but it has been the same before and seems to run fien
-
soo what is the problem then ..............i dont have a clue might it be the hgh speed needle i might of moved it .could it be inter fierence my transmitter is 27 hz am
-
anyhoo moving off the subject here
-
hey its not my fault im difflextic
-
any pics
-
oh yeah it there im not that stupid
-
pressure nipple or tube ???????? im a noobie so i dont know what these are
-
just tried it still going nuts i think it mite be water in the servo's as they were a bit damp
-
ok kool i will try run it again and once i have it fixed i will tune then engine
-
yeh i meean the carb but slo fuel is goin into the exaust is tat good
-
wait i think i know where the leak is ........i havent recable tied the air filter to the exaust so it mite be leaking in there it happened straigh after i took the cable tie off
-
it was a joke how would a wolf and a bird make a chicken ........and chikens are made out of clay check the labels .......made in Heaven.............size s...........99%clay...1%love rofl
-
hello i got a cen funfactor for christmas . it has been running fine already broken in but now ....randomly when i start it it revs to high and stalls -i think i nudges the high speed needle when checking to see if a screw driver would fit is this the problem