Orite chaps, I've been on the forum for a while now but only recently got into crawling from 1/5th scale petrol and 1/8 scale nitro, but I'm brand new to electric setups bar an old TT01 I had many many moons ago, hence the TRX4 thread.(which I'll write up abit later on)
Just a quick noobie question for now..
I set the XL5HV esc up to the 70/30 trigger config. And whilst reprograming the endpoints I noticed the throttle and reverse were backwards to what was mentioned in the programming guide. Would this point to the motor being soldered up to the wrong polarity? Also if I change the bullet connectors over in the pic shown, it shouldn't do any damage to anything else once the endpoints are reset again?
Thanks in advance.