Jump to content

El-Tel

Members
  • Posts

    6
  • Joined

  • Last visited

About El-Tel

  • Birthday 20/06/1984

Profile Information

  • Gender
    Male
  • Location
    Hampshire
  • Interests
    RC Cars, Darts, Lego, petrolhead, 🍺
  • RC Cars
    HPi RS4 Rally, HPi Nitro MT2 (Custom Brushless Conversion) Yokomo MR4 TC Custom, Tamiya M03, Tamiya TA-02, RaceOpt T3,

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

El-Tel's Achievements

Apprentice

Apprentice (3/14)

  • One Year In
  • Reacting Well Rare
  • First Post
  • Week One Done
  • One Month Later

Recent Badges

5

Reputation

  1. Hi Garry, thanks for your reply, ebay is the main place I have searched, or been searching. I managed to get a yr4 front diff as it ran 33t pulleys also, but the output shafts are too long, but I may be able to reuse the old or possibly the standard belt drive outputs as I believe they are the same. Unfortunately the manual doesn't have a full parts list.
  2. Cheers buddy! Yeah I picked up an SS as spares, so used the upgrades from that, it's a good fun truck for just ripping about!
  3. Thanks very much Yrkoon, I managed to acquire a SS too, so swapped in the cvd's, hardened diff outputs, adjustable turnbuckles and rear axle strengthener too.
  4. Hi, sorry for the delay, not been on for a bit, I must admit after the first few uses it certainly is a fantastic bit of kit! Unfortunately spares seem thin on the ground, I think front and rear diffs started to overheat, the front diff pulley is damaged but I managed to get another 33t diff set from the YR4 M2 as they were the same, but the output shafts are different. The rear was salvageable but the front needs the output shafts and I can use the rest of the front diff kit for the YR4 M2. Thanks for the reply though!
  5. Hi, I have a circa 2000 Yokomo MR4-TC Custom which has been an awesome bit of kit. Recently after doing a check over on a strip down and rebuild of parts I've found some diff wear and looking for some spares, unfortunately I've been struggling and wondered if anyone here has come across this or know of another front diff setup that would work? I believe the custom runs a narrow 33t diff pulley and have only been able to find the wide version or the 40t for the standard belt drive version. Any thoughts or ideas? Thanks in advance.
  6. Evening, thought I'd say a quick hello as been getting back in to some casual RC car use with some work mates. Dug out my old HPi RS4 Rally and gave it a once over, got some new batteries and been running that. Then converted my Nitro MT2 truck to brushless and picked up a Yokomo MR4 TC Custom, which has been awesome with the space to use it at work. Will post up a bit more on that in a proper post as need a bit of help. Great to get back in to the hobby though and been enjoying tinkering and driving them again.
×
×
  • Create New...