Chris Curby

If you do me a good deal on the Piggy Back Springs and those Rally Tires I may take them 😎

Thanks both @Gaz!and @Kpowell911 Now I know that I need a 3.2mm bore pinion I should be fine, they are cheap enough, thanks again 🙏

Regarding the Pinions the pictures shown are of the 14t 32P I purchased against the existing pinion removed from the 3351R motor. Clearly the inside diameter of the two are way out!! The simple issue is finding the right size pinion to suit the 3351R Motors shaft 😐 What am I missing here??

Damn that looks sweet!!

I had a good read of your thread earlier and got most of the good ideas from it 😂, I couldn't see any mention of the pinion though. And yes from a 2wd rustler it was. I just need to get a good setup on the spur and pinion so would prefer upgraded parts as opposed to stock.. Any suggestions or Links? I will upgrade the servo at a later date 👍

Hi All, So cracking on with my new project kindly supplied by @Gaz! for a fee of course 😁 I am looking at the following upgrades to begin with. Motor and ESC: Traxxas Velineon VXL-3S and 3351R Motor (taken from a Rustler) Traxxas Chassis Brace Kit (Blue) Traxxas Shocks GTR front and rear Arrma Dboots Hoons (White) New Shell designed and painted as a Ken Block Tribute shell My issue and question at the moment is the Pinion and Spur, @Gaz! can you remember if the spur is standard or have you upgraded in the past? The pinion i have at the moment is a 25t pulled from the Rustler so therefore to big really, the stock standard pinion is usually 13t so if I want to upgrade the spur to a Robinson Racing Gen3 Slipper Kit for a slash 4X4 (54T) what would be the recommended pinion size for the Robinson Spur?? I am going to place a large parts order tonight from Wheelspin so ideally need to know this before I do so. The Rally will mainly be ran on road so I am aiming for more top end speed. The Velineon setup is also very close together although it will just fit with a few mm spare between the ESC and Motor 🤨 I also noticed on a previous build by @Kpowell911 the servo was upgraded to a 9IMOD RC Brushless Servo, was this upgrade worthwhile? Or is standard stock ok? I have many more upgrades I want to do but for now I will do the ones above before boring you all with the list I want to fit. Cheers Chris 👍

Yes mate its the slash basically, i will give that a try and see what I get 👍

will these fit the Traxxas Rally 1/10? https://www.applianceelectronics.co.uk/viewproduct/31727/110-powerstroke-shocks-front-rear-2-traxxas-maxx

Hi All, Previously I only used Modelsport for spares but is there another well trust place then everyone here would swear by? Mainly for Traxxas spares and tune ups for the 4X4 Traxxas Rally/Slash... Cheers

Hi All, I am looking for a new Project and have my mind set on a Traxxas Rally, can be a roller so I can put my own stamp on it. The slash converts to a Rally so would take a slash chassis/Roller also. PM me please

I thought this was for the full kit? £150 for the shell? Good Luck...

Yes I was watching that one too, the white one? The others are XL-5 Motors I think (The Snap On ones) although not hard to convert to brushless... Actually I could just convert a 4X4 Slash right??

😆 can it convert to a Rally Car, I am in if so,,,,

As per the title, would prefer the Traxxas Rally if possible, please DM me if you have one spare/not in use... Thanks..

did you sell this?