nareshpatel10

If the buggy came with a pullstart, change it over to starter box, way easier to start the engine. Sent from my iPad using Tapatalk

Hi Guys, I need to buy a set of new tyres for my Hyper ST Truggy, but I'm confused on which size I need to look for. I currently have a set of Proline Crime Fighter MTR 5.65 x 2.72 (now obsolete) but can't seem to find a similar spec. Can anyone recommend any places to get them please, and thank you.

Mate I'll buy the wheel spanner Sent from my SM-A510F using Tapatalk

Hi sputnik sorry pal I'm totally new to this forum didn't realise you'd replied to my question. I've done the obvious things like replacing the fuel lines, checked if there's a leak in the fuel tank, checked for leaks on the carb by applying soapy water and blowing down the fuel line, seemed to be OK. Not checked the front bearings, but like I said all the parts on the engine are brand spanking new apart the the engine chassis (I know could've brought a brand new complete engine for what I paid out for the parts!!). Glow plugs ive been using (FASTRAX PLATINUM No.4 MEDIUM HOT) Headshims I can't remember as I built this last year before the summer. Fuel I've used a full 2.5L tub of Byron 25% trying to get this truggy going!! Here's a link of the video I took when I mange to get the engine going this is how it runs:- (https://youtu.be/2k580pvgcOA)

Hi is this a genuine HPI BAJA?

R u selling it mate Sent from my GT-I9505 using Tapatalk

Newbie to this site please advise. I have rebuilt a hyper 21 3 port engine on my hyper st truggy. I'm really struggling to tune it. When it idles and you rev the engine it revs really fast for ages until it slows down. Once it slows down then at times it just stalls. Then it's a mission to get it started again whilst the engine is hot. Any suggestions please Sent from my GT-I9505 using Tapatalk

Hi im a neewbie to nitro, I wanted to know the needle factory settings on a hpi trophy 3.5 engine. In the manual it states 3.5 turns from closed for both hsn and lsn. Can someone confirm if that means 1 turn=360 degree or 180 degrees?

Hi im a neewbie to nitro, I wanted to know the needle factory settings on a hpi trophy 3.5 engine. In the manual it states 3.5 turns from closed for both hsn and lsn. Can someone confirm if that means 1 turn=360 degree or 180 degrees?

Hi im a neewbie to nitro, I wanted to know the needle factory settings on a hpi trophy 3.5 engine. In the manual it states 3.5 turns from closed for both hsn and lsn. Can someone confirm if that means 1 turn=360 degree or 180 degrees?

Guide needed: Help with replacing the Spur Gear and re-assemble Description of problem: I've taken the spur gear out re-assembled the gearing transmission but moving the car back and forth it is not moving smoothly as it was before. Not sure if I have assembled the gearing transmission correctly!!