Jump to content

flash22

Members
  • Posts

    2,142
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • RC Cars
    vintage tamiya's, Marder, Gravel Hound, Sand Scorcher 2010, TA04-SS drift car, HPI recon, g.v dragrail

Recent Profile Visitors

4,410 profile views

flash22's Achievements

Apprentice

Apprentice (3/14)

  • Week One Done
  • One Month Later
  • One Year In
  • Piece of Furniture
  • First Post

Recent Badges

70

Reputation

  1. Satisfactory, on my 2nd play through 900+ hours and still going
  2. I volunteer at a cat rescue, one of the more unusual guests
  3. It's nothing special just an old Corsair Obsidian 750R, HX750 PSU, Gigabyte X390 Gaming X, Not long built a Mini ITX system, The first AMD system i have built in 20+ years (Ryzen 3 on B450 board) in a Node 304, CM 212evo, Noctua fans all round, again nothing special, it sits there and chews data
  4. It was my grandfathers from Stalag VIII-B in Poland
  5. Nuts isn't the word, AMD cards are in stock at retailers just double the MSRP, i will stick with my pair of RX480's not upgraded in a few years nothing special 9900K, 32gb CL16, 2xRX480, 500gb and 1tb 970 M.2 evo's that replaced my old X99 5820K setup Just sold an MSI R9 280 3Gb, someone paid £80 for it !!
  6. oddly - I media blasted my lunchbox shell a few weeks ago, I now have a design for the rear shock mounts and axle brace 3d printed in abs - thinking of printing a new front grille for the LB too My LB is now brushless with a 14t pinion - 2.2" beadlocks and the rest of the usual mods
  7. I cant remember the measurements of the Hobao, but the Hpi trophy flux motor mount (101317) is 22mm between bolt centres, I have one sitting here for a project
  8. I did a few - many moons ago and still have my hyper cage just surprised people are still doing them one I built up in late 2012
  9. Are people still doing these, the conversion mounts were always the hard bit to source IF you could find stock or wait a age for stock to come in
  10. Milled and drilled on my Milling machine manually, fettled with a file then a course and medium polish, they need another round of polishing tbh All the hex bar stock was done on the lathe, centre drilled, 2.5mm drill down 25mm on the main cross piece, faced off both ends, 3mm tap in 2 stages and then finally a polish 10mm hex spacers same as above but just a 3mm hole drilled with no thread All made with hi spec aircraft grade aluminium there not perfect and its the first time I have used this mill after killing my last mill 2 years ago, so a bit out of practice
  11. Fastrax shocks are the same as ansmann Fast166 75mm shocks Fast167 85mm shocks They also do the soft, med and hard springs just add s,m or h to the end of the part No. still not found anyone cheap enough to make the axle braces, so I made a 2 sets up not quite perfect and still need the last few stages of polishing
  12. stadium blitzer and 2wd blackfoot rims also fit, most 2.2" crawler tires fit the rims so there no end of tire types got to get motivated and get these cars done
×
×
  • Create New...