S.O.S. FTX Bugsta Ruining My Fun

[Stormbringer]

recheck the drive train is running smoothly with no binding as you should be able to use a lipo in a brushed setup

[SXFoxstar]

Thank you every one. One hardened, 3 stock and one incompatible steel spur later I finally have the Bugsta back up and running!

 

it seems the added on motor fan was slightly dislodging the motor position and also an over tightened slipper clutch were the cause of all of my issues!

 

I had almost given up but your advice saw me through.

 

Thank you!

[SimplyChunk]

1 hour ago, SXFoxstar said:

Thank you every one. One hardened, 3 stock and one incompatible steel spur later I finally have the Bugsta back up and running!

 

it seems the added on motor fan was slightly dislodging the motor position and also an over tightened slipper clutch were the cause of all of my issues!

 

I had almost given up but your advice saw me through.

 

Thank you!

Now rip it man!!!

[SXFoxstar]

This weekend I thought after discovering my add on motor fan was the cause of all my spur threading I thought I’d give the brushless another go. And it works perfectly!!!  Loving it again and using the Bugsta on our road it slides around almost like a drift car (which has now put that on my radar as a possible next purchase, along with the new 1/10 MJX)

Edited October 26, 2024 by SXFoxstar

[Ziggy122]

On 20/10/2024 at 14:56, SXFoxstar said:

This weekend I thought after discovering my add on motor fan was the cause of all my spur threading I thought I’d give the brushless another go. And it works perfectly!!!  Loving it again and using the Bugsta on our road it slides around almost like a drift car (which has now put that on my radar as a possible next purchase, along with the new 1/10 MJX)

just remember to keep checking everything after a few runs to ensure nowt is slipping out of place

 

Typically mesh dropping off is all fine the suddenly it's chews sumet in a split second!

 

ziggy