BuckRambo Posted June 12, 2022 Share Posted June 12, 2022 Hi, looking for some advice. I have a ACME Cyclone with a .18 Team Infinity Engine. I have all the carb setting set to default, the glow plug is new as is the fuel. The car has been in store for about 4 years and did run fine when stored. Now when I try and start it, it starts first pull but when I remover the Glow Starter the engine stalls. Don't want to start messing with carb settings yet until I know what might be the problem. If you guys and gals have any advice it would be much appreciated. Thanks in advance Buck Quote Link to comment Share on other sites More sharing options...
Jumper Posted June 12, 2022 Share Posted June 12, 2022 Probably too rich 1 Quote Link to comment Share on other sites More sharing options...
locky Posted June 12, 2022 Share Posted June 12, 2022 Either too rich or glow plug on its way out. 1 Quote Link to comment Share on other sites More sharing options...
BuckRambo Posted June 12, 2022 Author Share Posted June 12, 2022 Cheers I will take a look at the mixture 👍 Quote Link to comment Share on other sites More sharing options...
Mack1 Posted June 12, 2022 Share Posted June 12, 2022 I would recommend using a new glow plug. Sounds typical of a faulty but not blown plug. 1 Quote Link to comment Share on other sites More sharing options...
BuckRambo Posted June 13, 2022 Author Share Posted June 13, 2022 Had a mess about with it today, the glow plug is new as is the fuel, Jumper was spot on, leaned it out a bit and runs just fine. Thanks all for your input and advice 👍 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.